User manual PUR LINE HEATY 183E

[. . . ] Any other use is not recommended by the manufacturer and could cause fire, electrical shock, or injury to persons. Make certain that the power source conforms to the electrical requirements of heater. Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating and unattended. [. . . ] Locate the power cord so the heater or other objects are not resting on it, Do not run power cord under carpeting. Arrange power cord away from room traffic and where it will not be tripped over. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes and curtains at least 0. It must not be used in potentially dangerous locations such as flammable, explosive, chemical-laden or wet atmosphere. Never locate a heater where it may fall into a bathtub or other water container. Make sure that the heater is in the "OFF" position before plugging the heater into an outlet. When the heater is plugged in and turns on the power switch on the side of the unit, there will be a "beep" and a red power light to indicate that there is power to the unit. The red light will remain lit until the power switch is closed or the Upon turning the heater on, the unit will be in the HIGH heat mode (1800 watts), the LCD will display the current air temperature, and the fan start to run. When « Mode » button is pressed at this point, the heater will be set into LOW heat mode (1100 watts) and the "LOW" in the LCD will be highlighted. Pressing the « Mode » button once more will set the heater into AUTO mode (1800 watts). Notice that the display now displays a SET TEMP indicator (see THERMOSTAT INSTRUCTION). Pressing the « Mode » button again and the heater will go back to HIGH heat mode. To turn the heater off, press the « Power & Thermostat knob », and turn off the power switch, Then remove plug from outlet. Timer Function: The "TIMER" function allows users to set the time from 1 to 8 hours, and it is available under all HIGH/LOW/AUTO/FAN mode. When "TIMER" is off, pressing "TIMER" button will start this function and the right side of LCD screen displays 1, press again, it displays 2, then 3, 4, 5. "TIMER" turns to off after pressing the "TIMER" button while LCD displays 8, if press again, timer function will be restarted. "TIMER" will count down the hours in one hour increment until the machine turns to standby mode automatically. Pressing the « Mode » button until the display shows AUTO mode. [. . . ] Characteristics prone to change without notice WARRANTY: The warranty is valid for 2 years for a "manufacturing fault". To benefit from the warranty, please return the device to your dealer with POSTAGE PAID along with the document of purchase proof specifying the date of purchase. Discarding worn household devices The European directive 2002/96/EC pertaining to electrical and electronic waste prohibits such household goods from being discarded with local refuse services. [. . . ]