User manual PUR LINE HEATY 126

[. . . ] Make certain that the power source conforms to the electrical requirements of heater (AC220-240V ~ 50Hz). The appliance is not intended for use by young children or infirm persons without adequately supervision; Young children should be supervised to ensure that they do not play with the appliance. To reduce the risk of electric shock, this plug is intended to fit in a correct outlet. [. . . ] Arrange power cord away from room traffic and where it will not be tripped over. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes and curtains at least 0. It must not be used in potentially dangerous locations such as flammable, explosive, chemical-laden or wet atmosphere. Never locate a heater where it may fall into a bathtub or other water container 14. Make sure that the heater is in the "OFF" position before plugging the heater into an Outlet. When the heater is initially plugged in and turns on the power switch on the rear of the unit, there will be a « beep » and the power indicator will be on indicating that there is power to the unit. The indicator will remain lit until the power switch on the rear of the unit is turned off. Upon turning the heater on, the unit will be in the LOW heat mode (1100 watts), the « LO » and current room temperature will be displayed on LED circularly during 5 seconds. Pressing the " Power & Mode " button at this point will set the heater into the HIGH heat mode (1800 watts), the « HI » and current room temperature will be displayed on LED circularly during 5 seconds. Pressing the "Power & Mode" button at this point will set the heater into the AUTO mode (1800 watts). the LED will display the default temperature of 25° flickeringly. Notice that now C If you do not set the temperature in 3 seconds, the LED will stop blinking and will display the "AU" and current room temperature circularly during 5 seconds. Pressing the "Power & Mode" button once more will set the heater into the FAN mode (15 watts). The "FA" and current room temperature will be displayed on LED circularly during 5 seconds. Pressing the "Power & Mode "button again and the heater will go back to LOW heat mode. continuing to press the button will cycle the unit through LOW , HIGH , AUTO , FAN mode. To cut off the unit, press the "Power & Mode" button and hold 2 seconds. Do the same to turn the heater off, then turn off the power switch and remove plug from power outlet. [. . . ] If the alarm sounds, immediately turn the heater off and inspect for any objects on or adjacent to the heater that may cause high temperature. To benefit from the warranty, please return the device to your dealer with POSTAGE PAID along with the document of purchase proof specifying the date of purchase. Discarding worn household devices The European directive 2002/96/EC pertaining to electrical and electronic waste prohibits such household goods from being discarded with local refuse services. [. . . ]