User manual PRESIDENT WALKER

[. . . ] Take care not to damage the vehicle's electrical system while drilling the dash board. E) Do not forget to insert the rubber joints [3] between the CB and its support as these have a shock-absorbing effect which permits gentle orientation and tightening of the set. F) Choose where to place the microphone support and remember that the microphone cord must stretch to the driver without interfering with the controls of the vehicle. [. . . ] E) Go to Channel 20 using either the «UP» «DN» key on the microphone or the rotary knob. A) To turn the set on, turn the knob (1) clockwise b) To increase the sound level, turn the same knob further clockwise. This beep tone can be activated or disactivated by the user by following this procedure : a) Turn on the power while pressing the mic "UP" switch. WARNING: This must be carried out when you use your CB radio for the first time (and whenever you re-position your antenna). SWR 1 or SWR 2) a) To connect the SWR meter : - Connect the SWR meter between the CB radio and the antenna as close as possible to the CB (use a maximum of 40 cm cable, type President CA 2C). If this is not the case, re-adjust your antenna to obtain a reading as close as possible to 1. - It will be necessary to re-calibrate the SWR meter after each adjustment of the antenna. WARNING: In order to avoid any losses and attenuations in cables used for connection between the radio and its accessories, PRESIDENT recommends to use a cable with a length inferior to 3m. Squelch does not effect neither sound nor transmission power, but allows a considerable improvement in listening comfort. A) ASC: Automatic Squelch Control Worldwide patent, a PRESIDENT exclusivity No repetitive manual adjustment and a permanent improvement in listening comfort when this function is active. It can be disconnected by turning the switch (2) clockwise, in this case the manual squelch control becomes active again. RF GAIN can be reduced to avoid distortion, when your correspondent is close by and when he does not have RF POWER. Is for regulating microphone sensitivity, when using a microphone other than the one supplied with your PRESIDENT WALKER ASC. B) Manual squelch Turn the squelch knob clockwise to the exact point where all back-ground noise disappears. This adjustment should be done with precision as, if set to maximum, (i. The two keys, «UP» and «DN» on the microphone allow you to go up and down the channels. [. . . ] If you use a calling channel (19, 27) and you have established communication with someone, it is common practice to choose another available channel so as not to block the calling channel. Advertising Back off : Flashing lights of police car : Slow down Blocking the channel : Blue boys : Break : Breaker : Clean and green : Cleaner channel : Coming in loud and proud : Doughnut : Down and gone : Down one : Do you copy?: DX : Eighty eights : Eye ball : Good buddy : Hammer : Handle : Harvey wall banger : How am I hitting you? [. . . ]