User manual PRESIDENT PM-1200 WP

[. . . ] Pressing and holding the CLR key and the UP key while turning the power on will cause the microprocessor to reset and erase all the programmed channels from memory. [V/L] KEY (14) Pressing the [V/L] key enters the VOLUME CONTROL mode. In VOLUME CONTROL mode use the UP and DN keys to select your best audio output (Volume) level over a scale of P0 to P7. When pressed for 2 seconds the `keypad lock function' is activated/de-activated. [. . . ] To delete a channel from the radio's memory, press the "R/D" KEY again while the memorized channel is displayed on the LCD. The channels programmed into the radio's memory will remain even if the power is turned off. Scanning will advance from the lowest to the highest channel number in memory and will stop where a signal is received. Clearing The Radios Memory To erase all the channels that are stored in memory for scanning: Press and hold the "CLR" KEY and the "UP" KEY while simultaneously switching on the power. Transmitting Before transmitting, be sure that the channel is not being used. The display will show "HI" for high power or "LO" for low power. When receiving a call, wait until the call is finished before transmitting. Always release the "PTT" KEY immediately upon completion of transmission. To select the emergency channel, press the "CH16" KEY Transmit your emergency call To revert to previous channel from channel 16, press the "CLR" KEY. Duplex is a public correspondence, ship-to-shore channel which is mainly used by Marine Telephone Operators. A duplex channel cannot be used for ship-to-ship communications because the transmit and receive frequencies are not the same. NOTE : All channels are factory pre-programmed in accordance with International regulations, and mode of operation cannot be altered from simplex to duplex or vice versa. When the channel is not busy, press and hold the "PTT" switch and call the boat you want to communicate with. Once you have established contact, arrange to meet on another ship-to-ship channel (refer to the Marine Channel Charts on the back of the manual for available channels) to continue your conversation. Making Telephone Calls To make a radiotelephone call use a channel designated for this purpose. Press and hold the "PTT" switch and call the marine operator then identify yourself. You will reach the marine operator who will then connect your radio transmission to the telephone lines. Backlighting Press and hold [SD] key for two seconds to activate backlighting on PM1200 WP. The quality of the solid-state components used in this radio will provide many years of continuous use. However please take the following precautions to prevent damage to the radio. Keep the microphone jack covered at all times with the rainproof cap to prevent corrosion of electrical contacts. Never key the transmitter unless an antenna or suitable dummy load is connected to the antenna receptacle. [. . . ] Our technical department won't send nor exchange any spare parts as part of warranty. Are not covered In our offices, neither by a change of one or more components or spare parts. Interventions that modified the conformity features, repairs or modifications done by third parties which are not agreed by our company. The [PSC] key does not No channel SAVED into Use the [R/D] key to memorize desired chanthe radio's memory make the radio scan nels into the radio's memory Constant noise output Squelch is not adjusted Adjust the squelch to threshold or to the point where noise just disappears. [. . . ]