User manual POWERDSINE PD-6506

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual POWERDSINE PD-6506. We hope that this POWERDSINE PD-6506 user guide will be useful to you.


POWERDSINE PD-6506 : Download the complete user guide (289 Ko)

Manual abstract: user guide POWERDSINE PD-6506

Detailed instructions for use are in the User's Guide.

[. . . ] 6 2 ABOUT THE POWER OVER ETHERNET MIDSPAN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 2. 1 Power Management . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 2. 2 10/100BASE-TX Ports Definition. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 2. 3 Indicators. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 2. 4 Connectors. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The supply plug must comply with section 107-2-D1, standard DK2-1a or DK2-5a. If your supplies are of the IT type, this unit must be powered by 230 V (2P+T), via an isolation transformer with a 1:1 ratio and with the secondary connection point labeled Neutral, connected directly to ground The Power over Ethernet Midspan is covered by General Approval, NS/G/12345/J/100003, for indirect connection to a public telecommunications system 6 The Power over Ethernet Pioneers · · U. S. A. and Canada Denmark Switzerland France and Peru U. K PowerDsine PowerDsine 6500 Series 2 About the Power over Ethernet Midspan PowerDsine's family of Power over Ethernet Midspans, series 3500 & 6500, injects power over data-carrying Ethernet cabling. The PD6506/6512/6524 Midspans, support 6, 12 and 24 ports respectively in a 10/100BaseTx Ethernet network, over TIA/EIA-568 Category 5/5e/6 cabling. DC operating power, for data terminal units, is fed over unused pairs of the cabling (7/8 and 4/5). The Power over Ethernet Midspan normally powers devices that are `Power over Ethernet Enabled'or are equipped to receive power over Ethernet. Devices that are not can receive power over Ethernet, may require an external power adapter in order to be powered. Power over Ethernet Midspan main features: Safe and reliable power over existing Ethernet infrastructure Eliminates the need for AC outlets, local UPS & AC/DC adapters near PDs Remote Management using Web control and/or SNMPv3 Highest level of Network Security Safe solution that protects network infrastructure Standards compliant. 2. 1 Power Management When establishing a network, the total power required by the PDs may exceed the total power available from the Midspan. The built-in Power Management feature does not allow total power output to exceed maximum power available (refer to the Technical Specifications). When total power available is near maximum, attempts to connect an additional PD to a free port cause the corresponding LED of the port to blink orange, indicating an out-of-power state. Power distribution is based on "first come, first served" logic. Sometimes, connected and operating PDs significantly increase or suddenly raise their power requirements. If the power required exceeds the power available, the Midspan starts turning off ports, starting from the last port down, until the total power is once again under the maximum PowerDsine 7 The Power over Ethernet Pioneers PowerDsine 6500 Series available limit. 2. 2 10/100BASE-TX Ports Definition 2. 2. 1 Data Input Ports The Midspan has 6, 12 or 24 x 10/100Base-T Data In ports, located on the PoE rear panel (Figure 2-1), configured in a non-crossover manner (straight-wired). These ports are located on the PoE's rear panel designed to carry Ethernet data only (Tx/Rx) over the standard 2-wire pairs (pins 1/2 and 3/6) and are typically connected to an existing Ethernet switch. 2. 2. 2 Data & Power Output Ports The Midspan has 6, 12 or 24 x 10/100Base-T Data & Power Out ports, located on the front panel (Figure 2-2). These ports are configured in a non-crossover manner (straight-wired) and are designed to carry Ethernet data over the standard 2-wire pairs (pins 1/2 and 3/6) and DC power over the spare pairs (pins 4/5 and 7/8). Each output port corresponds to an opposite input port located on the PoE rear panel. . As such, the maximum distance from the Ethernet switch must not exceed 100 meters (328 ft). As specified in the IEEE 802. 3 standard, the Power over Ethernet Midspan is guaranteed to work up to this distance. Figure 2-2: Power over Ethernet Midspan, Front View (PD-6524) PowerDsine 8 The Power over Ethernet Pioneers PowerDsine 6500 Series 2. 3 Indicators A set of indicators provide the status of the Power over Ethernet Midspan and its ports. Refer to Table 2-1 and Table 2-2 for status information during operation. 2. 3. 1 Primary Power Indicators The "Main" LED on the front panel provides the Power over Ethernet Midspan power status. When the Main indicator is illuminated in green, the Midspan receives AC power. [. . . ] Verify that for this link, you are using a standard UTP/FTP Category 5 straight (non-crossover) cabling, with all four pairs. Try to re-connect the same PD to a different port on the same midspan or to a different unit: if it works, there is probably a faulty port or faulty RJ-45 connection. During these conditions, port power is disconnected. Is it safe to keep the Midspan running while a port indicator is orange? PowerDsine 16 The Power over Ethernet Pioneers PowerDsine 6500 Series 5 5. 1 Technical Specifications Physical Specifications 44 x 435 x 271 mm (1. 75 x 17. 2 x 10. 7 inch) 5Kg (11lb) Dimensions (h x w x l) Weight 5. 2 Environmental Specifications 0 to 40 °C (32 to 104 °F) -20 to 70 °C (-4 to 158 °F) 10 to 90% (non-condensing) Temperature - Operating - Storage Humidity 5. 3 Electrical Specifications Parameter PD-6506/6512/6524/AC/M 4 A max. 90 to 264 VAC at 47-63 Hz AC Input Voltage Input Current @ 115 VAC Total Output Power Output Power, per Port Nominal Output Voltage 15. 4 W (not to exceed Total Output Power) PowerDsine 17 The Power over Ethernet Pioneers PowerDsine 6500 Series 6 PowerDsine's PowerView Pro PowerDsine PowerView Pro is a secure remote management system offering real time monitoring and control, with graphical representation, status indicators, and alarms. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE POWERDSINE PD-6506




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual POWERDSINE PD-6506 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.