User manual POWERDSINE 6001

[. . . ] Safety Information (cont. ) ~ WARNING Read the installation instructions before connecting the Power over LAN Hub to its power source. ~ WARNING Follow basic electricity safety measures whenever connecting the Power over LAN Hub to its power source. 1-Port Power over LAN Hub User Guide Notice It is PowerDsine's policy to improve its products as new technology, components, software, and firmware become available. PowerDsine, therefore, reserves the right to change specifications without prior notice. ~ WARNING This product relies on the building installation for short-circuit (over current) protection. (240 VAC, 1. 5A international) is used on the phase conductor. ~ WARNING A voltage mismatch can cause equipment damage and may pose a fire hazard. [. . . ] (Power is active) Troubleshooting · Ensure AC power is applied to the Power over LAN Hub, using an operational AC cable with an appropriate ground connection. · Ensure the use of a standard 4 pair (8 wires) UTP or FTP CAT5 cable. · Ensure a "crossover" type Ethernet cable is not used. · Ensure input Ethernet cable is connected to the Data In port. · Ensure output Ethernet cable is connected to the Data & Power Out port. · Verify that the Ethernet cable length is less than 100 meters from the Ethernet source to the load. · Verify that power ready Ethernet compatible device is connected. · Verify that you are not using any cross over cable between the Power over LAN Hub output port and the load device. · Verify that there is no short over any of the twisted pair cables or over the RJ45 connectors. Specifications Environmental Specifications Mode Operating Storage Temperature 0 to 50 °C 32 to 122°F -20 to 70 °C -4 to 158°F Humidity 10 to 90% (no condensation allowed) 10 to 90% (no condensation allowed) Installation The Power over LAN Hub may be free standing or wall mounted using the back wall holders. NOTE: Before you mount the Power over LAN Hub to a fixed location: · Ensure not to cover the Power over LAN Hub or block the airflow to the Power over LAN Hub with any other objects. Keep the Power over LAN Hub away from excessive heat and humidity, and free from vibration and dust. · Ensure that the cable length from the Ethernet network source to the terminal does not exceed 100 meters (333 Feet). The Power over LAN Hub is not a repeater and does not amplify the Ethernet data signal Installing the Unit · Connect the Power over LAN Hub to an AC outlet (100240 VAC), using a standard power cord. · Connect the unit Data In jack (input) to the Ethernet network and the Data & Power Out jack (output) to the terminal. Electrical Specifications Input Voltage Input Current at 110 VAC Input Current at 220 VAC Minimum Available Output Power Nominal Output Voltage Ethernet Interface Input (Data In): Ethernet 10/100Base-T Output (Data & Power Out): Ethernet 10/100Base-T, plus 48 VDC RJ 45 female socket RJ 45 female socket, with DC voltage on wire pairs 7-8 and 4-5. [. . . ] · The Power over LAN Hub data and data / power interfaces are qualified as SELV (Safety Extra-Low Voltage) circuits according to IEC 60950. These interfaces can only be connected to SELV interfaces on other equipment. PowerDsine 6001 Data & Power Out Data In Port Connectivity Indicators Power Active Main IEEE 802. 3af Compliant Port Output Port Input Cat. 5 Cable Terminal Ethernet Figure 1: Illustration of connectivity for the Power over LAN Hub. [. . . ]