User manual POULAN PRO PR10527ESA

[. . . ] IMPORTANT MANUAL Do Not Throw Away OWNER'S MANUAL MODEL NUMBER: WARNING: Read the Owner's Manual and follow all Warnings and Safety Instructions. Failure to do so can result in serious injury. PR10527ESA SNOW THROWER Always Wear Eye Protection During Operation 192042 Rev. 2 08. 13. 04 BY Printed in U. S. A. SAFETY RULES Safe Operation Practices for Snow Throwers IMPORTANT: This machine is capable of amputating hands and feet and throwing objects. Failure to observe the following safety instructions could result in serious injury or death. [. . . ] 19) The engine on your snow thrower has been shipped, from the factory, already filled with oil. Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw tight, wait for a few seconds, remove and read oil level. If necessary, add oil until "FULL" mark on dipstick is reached. · To change engine oil, see "TO CHANGE ENGINE OIL" in the Maintenance section of this manual. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness. 12 TO START ENGINE · Be sure fuel shut-off valve is in the OPEN position. The electric starter is equipped with a three-wire power cord and plug and is designed to operate on 120 Volt A. C. WARNING: Do not use the electric starter if your house is not a 120 Volt A. C. Serious personal injury or damage to your snow thrower could result. OPERATION COLD START - ELECTRIC STARTER 1. Plug the other end of the power cord into a three-hole grounded 120 Volt A. C. NOTE: Do not use primer when starting engine with the electric starter. IMPORTANT: Do not crank engine more than five continuous seconds between each time you try to start. When the engine starts, release the starter button and slowly move the choke control to the OFF position. Disconnect the power cord from the receptacle first, then from the engine. Engine will not develop full power until it has reached normal operating temperature. WARM START - ELECTRIC STARTER Follow the steps above, keeping the choke control in the OFF position. Push the primer four (4) times if the temperature is below 15°F, or two (2) times if temperature is between 15° and 50°F. NOTE: Over priming may cause flooding, preventing the engine from starting. If you do flood the engine, wait a few minutes before attempting to start and DO NOT push the primer. When the engine starts, release the recoil starter handle and slowly move the choke control to the OFF position. Engine will not develop full power until it has reached normal operating temperature. [. . . ] FUEL SYSTEM IMPORTANT: It is important to prevent gum deposits from forming in essential fuel system parts such as carburetor, fuel hose, or tank during storage. Also, alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. 18 TROUBLESHOOTING See appropriate section in manual unless directed to a qualified service centre. PROBLEM CAUSE CORRECTION Does not start 1. Contact a qualified service centre. Loss of power Engine idles or runs roughly Excessive vibration Recoil starter is hard to pull Loss of traction drive / slowing of drive speed Loss of snow discharge or slowing of snow discharge 1. [. . . ]