User manual POULAN PRO PP338PT

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual POULAN PRO PP338PT. We hope that this POULAN PRO PP338PT user guide will be useful to you.


POULAN PRO PP338PT : Download the complete user guide (475 Ko)

You may also download the following manuals related to this product:

   POULAN PRO PP338PT (487 ko)

Manual abstract: user guide POULAN PRO PP338PT

Detailed instructions for use are in the User's Guide.

[. . . ] Veuillez ne pas retourner l'outil au détaillant. 1-800-554-6723 www. poulan-pro. com Instruction Manual Manual de Instrucciones Manuel d'Instructions ESPAÑOL PP338PT For Occasional Use Only WARNING: Read and follow all Safety Rules and Operating Instructions before using this product. ADVERTENCIA: Lea el manual de instrucciones y siga todas las advertencias e instrucciones de seguridad. AVERTISSEMENT: Lire le manuel d'instructions et bien respecter tous les avertissements et toutes les instructions de sécurité. Tout défaut de le faire pourrait entraîner des blessures graves. Poulan PRO 7349 Statesville Road Charlotte, NC 28269 Poulan PRO 850 Matheson Blvd. [. . . ] This will cause permanent engine damage and void the limited warranty. FUEL REQUIREMENTS IMPORTANT This engine requires the use of minimum 87 octane [R+M]/2 clean gasoline. Use of alcohol blended fuels (called gasohol or using ethanol or methanol) can cause major engine performance and durability problems. Starting Position WARNING: Alternative fuels (not gasoline) such as E- (15% alcohol), E- (20% -15 -20 alcohol), E- (85% alcohol) are NOT classified -85 as gasoline and are NOT approved for use in 2-stroke gasoline engines. Use of alternative fuels will cause problems such as: improper clutch engagements, overheating, vapor lock, power loss, lubrication deficiency, deterioration of fuel lines, gaskets and internal carburetor components, etc. Alternative fuels cause high moisture absorption into the fuel/oil mixture leading to oil and fuel separation. BAR AND CHAIN LUBRICATION The bar and chain require lubrication. The chain oiler provides continuous lubrication to the chain and guide bar. Be sure to fill the bar oil tank when you fill the fuel tank (Capacity = 4. 6 fl. Too little oil will cause overheating shown by smoke coming from the chain and/or discoloration of the bar. Genuine Poulan or Poulan PRO bar and chain oil is recommended to protect your unit against excessive wear from heat and friction. If Poulan or Poulan PRO bar and chain oil is not available, use a good grade SAE 30 oil. S Always stop the engine before removing the oil cap. If your engine still does not start after following these instructions, please call 1- 800- 554- 6723. Starter Handle Primer Bulb STARTING A COLD ENGINE NOTE: DO NOT squeeze the throttle trigger Throttle Trigger Start Lever 4. 5. Muffler Pull starter rope handle sharply until engine starts and runs. Allow unit to run for 10-15 seconds, then fully squeeze the throttle trigger to disengage the starting system. HOW TO STOP YOUR UNIT S Release the throttle trigger. Wait 5 seconds before attempting to restart unit to allow switch to reset. Pull starter rope sharply while squeezing throttle trigger until engine runs. NOTE: Normally, the warm starting procedure can be used within 5-10 minutes after the unit is turned off. If the unit sits for more than 10 minutes without being ran, it will be necessary to start the unit by following the steps under STARTING A COLD ENGINE or following the starting instruction steps shown on the unit. STARTING A WARM ENGINE STARTING A FLOODED ENGINE ON/STOP Switch Move the start lever to the RUN position and fully squeeze throttle trigger. Pull the starter handle repeatedly while squeezing throttle trigger until engine starts and runs. This could require pulling the starter handle many times, depending on how badly the unit is flooded. If the unit still doesn't start, refer to TROUBLESHOOTING TABLE or call 1-800-554-6723. OPERATING THE COUPLER HOW TO START YOUR UNIT WARNING: Make sure the chain will not make contact with any object while starting the engine. A hot muffler can cause serious burns. 13 This model is equipped with a coupler which enables optional attachments to be installed. [. . . ] Where a warrantable condition exists, Poulan PRO will repair your small off-road engine at no cost to you. MANUFACTURER'S WARRANTY COVERAGE: If any emissions related part on your engine (as listed under Emissions Control Warranty Parts List) is defective or a defect in the materials or workmanship of the engine causes the failure of such an emission related part, the part will be repaired or replaced by Poulan PRO. OWNER'S WARRANTY RESPONSIBILITIES: As the small off-road engine owner, you are responsible for the performance of the required maintenance listed in your instruction manual. Poulan PRO recommends that you retain all receipts covering maintenance on your small off-road engine, but Poulan PRO cannot deny warranty solely for the lack of receipts or for your failure to ensure the performance of all scheduled maintenance. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE POULAN PRO PP338PT




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual POULAN PRO PP338PT will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.