User manual POULAN PRO PP25E

[. . . ] www. poulan-pro. com 1-800-554-6723 Instruction Manual Manual de Instrucciones Manuel d'Instructions PP25E ESPAÑOL For Occasional Use Only WARNING: Read and follow all Safety Rules and Operating Instructions before using this product. ADVERTENCIA: Lea el manual de instrucciones y siga todas las advertencias e instrucciones de seguridad. AVERTISSEMENT: Lire le manuel d'instructions et bien respecter tous les avertissements et toutes les instructions de sécurité. Tout défaut de le faire pourrait entraîner des blessures graves. Poulan PRO 1030 Stevens Creek Road Augusta, GA 30907 Poulan PRO 850 Matheson Blvd. [. . . ] It is designed to cut grass. DEPTH ADJUSTMENT KNOB BLADE The DEPTH ADJUSTMENT KNOB is used to adjust the wheel for blade cutting depth when edging. The BLADE is designed to cut sod. BEFORE STARTING ENGINE FUELING ENGINE when refueling. WARNING: Be sure to read the fuel information in the safety rules before you begin. If you do not understand the safety rules, do not attempt to fuel your unit. WARNING: Remove fuel cap slowly ON/STOP Switch HOW TO START YOUR UNIT To obtain the correct oil mix ratio, pour 3. 2 ounces of 2- cycle synthetic oil into one gallon of fresh gas. Before operation, gasoline must be mixed with a good quality synthetic 2-cycle air-cooled engine oil designed to be mixed at a ratio of 40:1. A 40:1 ratio is obtained by mixing 3. 2 fluid ounces (95 ml) of oil with 1 gallon (4 liters) of unleaded gasoline. Once oil is added to gasoline, shake container momentarily to assure that the fuel is thoroughly mixed. Always read and follow the safety rules relating to fuel before fueling your unit. This will cause permanent engine damage and void the limited warranty. HELPFUL TIP WARNING: Avoid any contact with the muffler. A hot muffler can cause serious burns. Starting position If your engine still does not start after following these instructions, please call 1- 800- 554- 6723. Primer Bulb HELPFUL TIP STARTING A COLD ENGINE NOTE: DO NOT squeeze the throttle trigger FUEL REQUIREMENTS IMPORTANT This engine requires the use of minimum 87 octane [R+M]/2 clean gasoline. Use of alcohol blended fuels (called gasohol or using ethanol or methanol) can cause major engine performance and durability problems. HOW TO STOP YOUR UNIT WARNING: Alternative fuels (not gasoline) such as E- (15% alcohol), E- (20% -15 -20 alcohol), E- (85% alcohol) are NOT classified -85 as gasoline and are NOT approved for use in 2-stroke gasoline engines. Use of alternative fuels will cause problems such as: improper clutch engagements, overheating, vapor lock, power loss, lubrication deficiency, deterioration of fuel lines, gaskets and internal carburetor components, etc. Alternative fuels cause high moisture absorption into the fuel/oil mixture leading to oil and fuel separation. Start Lever S Release the throttle trigger. Wait 5 seconds before attempting to restart unit to allow switch to reset. Starter Handle 11 4. Allow unit to run for 10-15 seconds, then fully squeeze the throttle trigger to disengage the starting system. Locking/Release Button STARTING A WARM ENGINE 1. Pull starter rope sharply while squeezing throttle trigger until engine runs. NOTE: Normally, the warm starting procedure can be used within 5- minutes after the unit is -10 turned off. If the unit sits for more than 10 minutes without being ran, it will be necessary to start the unit by following the steps under STARTING A COLD ENGINE or following the starting instruction steps shown on the unit. Coupler Upper Shaft Attachment 3. While securely holding the engine and upper shaft, pull the attachment straight out of the coupler. INSTALLING OPTIONAL ATTACHMENTS 1. 4. STARTING A FLOODED ENGINE Flooded engines can be started by placing the start lever to the RUN position. Pull the starter handle repeatedly while squeezing throttle trigger until engine starts and runs. This could require pulling the starter handle many times, depending on how badly the unit is flooded. [. . . ] OWNER'S WARRANTY RESPONSIBILITIES: As the small off-road engine owner, you are responsible for the performance of the required maintenance listed in your instruction manual. Poulan PRO recommends that you retain all receipts covering maintenance on your small off-road engine, but Poulan PRO cannot deny warranty solely for the lack of receipts or for your failure to ensure the performance of all scheduled maintenance. As the small off-road engine owner, you should be aware that Poulan PRO may deny you warranty coverage if your small offroad engine or a part of it has failed due to 20 abuse, neglect, improper maintenance, unapproved modifications, or the use of parts not made or approved by the original equipment manufacturer. You are responsible for presenting your small off-road engine to an Poulan PRO authorized repair center as soon as a problem exists. [. . . ]