User manual POULAN BC2400P

[. . . ] Veuillez ne pas retourner l'outil au détaillant. 1-800-554-6723 www. poulan. com Operator's Manual Manual del Operador Manuel de L'utilisateur ESPAÑOL BC2400P UL R For Occasional Use Only DANGER: Read and follow all Safety Rules and Operating Instructions before using this product. PELIGRO: Lea el manual del operador y siga todas las advertencias e instrucciones de seguridad. DANGER: Lire le manuel de l'utilisateur et bien respecter tous les avertissements et toutes les instructions de sécurité. Tout défaut de le faire pourrait entraîner des blessures graves. Electrolux Home Products North America Div. [. . . ] S Install the blade nut by threading onto the shaft counterclockwise. NOTE: Make sure all parts are in place as illustrated, and the blade is sandwiched between the dust cup and the retaining washer. There should be no space between the blade and the dust cup or the retaining washer. S Rotate blade nut until the locking lever falls into one of the grooves in the dust cup. If the blade binds against the shield, or appears to be uneven, the blade is not centered, and you must reinstall. FUEL YOUR UNIT WARNING: Remove fuel cap slowly when refueling. Gasoline must be mixed with a good quality 2-cycle air-cooled engine oil designed to be mixed at a ratio of 40:1. (A 40:1 ratio is obtained by mixing 3. 2 ounces of oil with 1 gallon of unleaded gasoline). Always read and follow the safety rules under FUEL SAFETY. 6 STARTING HOW TO STOP YOUR UNIT To stop the engine, move the ON/OFF switch to the OFF position. USING YOUR UNIT OPERATING POSITION HOW TO START YOUR UNIT Starting Position WARNING: The trimmer head will turn while starting the engine. S Rest engine and shield on ground, supporting trimmer head off ground. ON/OFF Switch Throttle Trigger Starter Handle Primer Bulb S Extend your left arm and hold handlebar grip with your left hand. S Hold throttle grip with your right hand with finger on throttle trigger. S Keep shoulder strap pad centered on your left shoulder and danger sign centered on your back. S Without bending over, keep the blade or trimmer head near and parallel to the ground and not crowded into material being cut. OPERATING INSTRUCTIONS FOR USE WITH TRIMMER HEAD Choke Lever Muffler COLD ENGINE (or warm engine after running out of fuel) S Move the ON/OFF switch to the ON position. S Squeeze the throttle trigger fully and hold through all remaining steps. S Allow engine to run 10 seconds, then move choke lever to OFF CHOKE position. Before trimming, bring engine to a speed sufficient to cut material to be trimmed. The cutting line will cut efficiently when the engine is run at less than full throttle. The cutting line will last longer and will be less likely to "weld" onto the spool. If trimmer head does not turn when the engine is in operation, make sure the tube is properly seated in engine shroud. Always release the throttle trigger and allow the engine to return to idle speed when not cutting. S If engine does not stop, move choke to the FULL CHOKE position. ADVANCING THE TRIMMER LINE Advance line by tapping the bottom of the cutting head lightly on the ground while engine is running at full speed. The line limiter blade (on underside of shield) will cut the line to the proper length. STARTING A WARM ENGINE S Move the ON/OFF switch to the ON position. S If engine does not start in 5 pulls, follow instructions in STARTING A COLD ENGINE. WARNING: Use only 0. 080" (2 mm) diameter line. Other sizes of line will not advance properly and can cause serious injury. Wire can break off during cutting and become a dangerous missile that can cause serious injury. 7 S Blade Thrust is a reaction that only occurs when using a bladed unit. [. . . ] Your emission control system includes parts such as the carburetor and the ignition system. Where a warrantable condition exits, POULAN/WEED EATER will repair your lawn and garden equipment engine at no cost to you. MANUFACTURER'S WARRANTY COVERAGE: If any emissions related part on your engine (as listed under Emissions Control Warranty Parts List) is defective or a defect in the materials or workmanship of the engine causes the failure of such an emission related part, the part will be repaired or replaced by POULAN/WEED EATER. OWNER'S WARRANTY RESPONSIBILITIES: As the lawn and garden equipment engine owner, you are responsible for the performance of the required maintenance listed in your Owner's Manual. [. . . ]