User manual POULAN 3750

[. . . ] Veuillez ne pas retourner l'outil au détaillant. 1-800-554-6723 www. poulan. com Operator's Manual Manual del Operador Manuel de L'utilisateur 3450 3750 ESPAÑOL WARNING: ADVERTENCIA: UL R Read and follow all Safety Rules and Operating Instructions before using this product. Failure to do so can result in serious injury. Lea el manual del operador y siga todas las advertencias e enstrucciones de seguridad. El no hacerlo puede resultar en lesiones graves. Frigidaire Home Products, Augusta, GA 30907 WCI Outdoor Products, Inc. 530087292 12/07/99 SAFETY RULES WARNING: Always disconnect spark plug wire and place wire where it cannot contact spark plug to prevent accidental starting when setting up, transporting, adjusting or making repairs except carburetor adjustments. Because a chain saw is a high-speed woodcutting tool, special safety precautions must be observed to reduce the risk of accidents. [. . . ] NOTE: If the throttle trigger is squeezed during starting, it will be necessary to reset the fast idle lock. S Pull the starter rope quickly with your right hand until the engine attempts to start, then push the choke lever to the half position. S Pull the starter rope quickly with your right hand until the engine starts. S Above 40 degrees, allow the engine to run for approximately five seconds, then push the choke knob to the off position. Then, squeeze and release the throttle trigger to release the fast idle, allowing the engine to idle. S Below 40 degrees, allow the engine to warm up 30 seconds to one minute at half choke. Push choke knob to the off position; Then, squeeze and release the throttle trigger to allow engine to idle. Squeeze and hold the throttle trigger; Press and hold the fast idle lock with your forefinger; release the throttle trigger. Difficult starting or flooded engine: The engine may be flooded with too much fuel if it has not started after 10 pulls. Flooded engines can be cleared of excess fuel by following the warm engine starting procedure listed above. Starting could require pulling the starter rope handle many times depending on how badly the unit is flooded. If engine fails to start refer to the troubleshooting chart or call your Authorized Service Dealer. electrical wires if you do not know the direction of tree fall, at night since you will not be able to see well, or during bad weather such as rain, snow, or strong winds. You need a clear area all around the tree so you can have secure footing. Check for broken or dead branches which can fall on you causing serious injury. Natural conditions that can cause a tree to fall in a particular direction include: S The wind direction and speed. The lean of a tree might not be apparent due to uneven or sloping terrain. Maintain a distance of 2-1/2 tree lengths from the nearest person or other objects. Remove dirt, stones, loose bark, nails, staples, and wire from the tree where cuts are to be made. Plan a clear retreat path TREE FELLING TECHNIQUES WARNING: Do not cut near buildings or S Stop the saw if the chain strikes a foreign object. Even a small amount of dirt will quickly dull a chain and increase the possibility of kickback. S Practice cutting a few small logs using the following techniques to get the "feel" of using your saw before you begin a major sawing operation. S Squeeze the throttle trigger and allow the engine to reach full speed before cutting. [. . . ] This warranty is not transferable and does not cover damage or liability caused by improper handling, improper maintenance, or the use of accessories and/or attachments not specifically recommended by Frigidaire Home Products for this chain saw. Additionally, this warranty does not cover damage caused by improper handling, improper maintenance, or if the saw is altered in any way which in our judgement affects its condition or operation. This warranty does not cover tune---up, spark plugs, filters, starter ropes, starter springs, chain sharpening, bars, chains, and other parts which wear and require replacement with reasonable use during the warranty period. This warranty does not cover predelivery set---up, installation of guide bar and chain, and normal adjustments explained in the operator's manual such as carburetor adjustments and chain tension adjustments. [. . . ]