User manual POULAN 260LE

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual POULAN 260LE. We hope that this POULAN 260LE user guide will be useful to you.


POULAN 260LE : Download the complete user guide (701 Ko)

You may also download the following manuals related to this product:

   POULAN 260LE (617 ko)

Manual abstract: user guide POULAN 260LE

Detailed instructions for use are in the User's Guide.

[. . . ] ENGLISH R Instruction Manual Manual de Instrucciones Manuel d'Instructions 220 LE / 260 LE ESPAÑOL For Occasional Use Only WARNING: Read and follow all Safety Rules and Operating Instructions before using this product. Failure to do so can result in serious injury. ADVERTENCIA : Lea el manual de instrucciones y siga todas las advertencias e enstrucciones de seguridad. El no hacerlo puede resultar en lesiones graves. AVERTISSEMENT: Lire le manuel d'instructions et bien respecter tous les avertissements et toutes les instructions de sécurité. Tout défaut de le faire pourrait entraîner des blessures graves. Electrolux Home Products, Inc. [. . . ] Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. See STORAGE section for additional information. 9 ON/STOP Switch Primer Bulb ON/STOP SWITCH S If the brake is already activated, it is disengaged by pulling the front hand guard back toward the front handle as far as possible. S When cutting with the saw, the chain brake must be disengaged. Disengaged Engaged ON STOP CHOKE/FAST IDLE LEVER (SIDE VIEW) Braking function control CAUTION: The chain brake must be checked several times daily. This is the only instance when the saw should be placed on the ground with the engine running. Grip the rear handle with your right hand and the front handle with your left hand. Activate the chain brake by turning your left wrist against the hand guard without releasing your grip around the front handle. The chain should stop immediately. Choke/Fast Idle Lever OFF FULL STARTING A WARM ENGINE: 1. Pull the choke/fast idle lever out to the full extent, then push the lever back in completely (to the OFF position). Pull the starter rope quickly with your right hand until the engine starts. Squeeze and release throttle trigger, allowing engine to idle. Inertia activating function control DIFFICULT STARTING (or starting a flooded engine): The engine may be flooded with too much fuel if it has not started after 10 pulls. Flooded engines can be cleared of excess fuel by following the warm engine starting procedure listed above. Starting could require pulling the starter rope handle many times depending on how badly the unit is flooded. If engine fails to start, refer to the TROUBLESHOOTING TABLE or call 1-800-554-6723. WARNING: When performing the following procedure, the engine must be turned off. Grip the rear handle with your right hand and the front handle with your left hand. Release your grip on the front handle and use the weight of the saw to let the top of the guide bar fall forward and contact the stump. When the tip of the bar hits the stump, the brake should activate. CUTTING METHODS IMPORTANT POINTS S Check chain tension before first use and after 1 minute of operation. Do not cut metal, plastics, masonry, non-wood building materials, etc. Even a small amount of dirt will quickly dull a chain and thus increase the possibility of kickback. S Practice cutting a few small logs using the following techniques to get the "feel" of using your saw before you begin a major sawing operation. S Squeeze the throttle trigger and allow the engine to reach full speed before cutting. S Begin cutting with the saw frame against the log. CHAIN BRAKE WARNING: If the brake band is worn too thin it may break when the chain brake is triggered. The chain brake should be replaced by an authorized service dealer if any part is worn to less than 0. 020! [. . . ] MANUFACTURER'S WARRANTY COVERAGE: If any emissions related part on your engine (as listed under Emissions Control Warranty Parts List) is defective or a defect in the materials or workmanship of the engine causes the failure of such an emission related part, the part will be repaired or replaced by ELECTROLUX HOME PRODUCTS, INC. OWNER'S WARRANTY RESPONSIBILITIES: As the small off--road engine engine owner, you are responsible for the performance of the required maintenance listed in your instruction manual. ELECTROLUX HOME PRODUCTS, INC. , recommends that you retain all receipts covering maintenance on your small off--road engine, but ELECTROLUX HOME PRODUCTS, INC. , cannot deny warranty solely for the lack of receipts or for your failure to ensure the performance of all scheduled maintenance. As the small off--road engine engine owner, you should be aware that ELECTROLUX HOME PRODUCTS, INC. , may deny you warranty coverage if your small off--road engine engine or a part of it has failed due to abuse, neglect, improper maintenance, unapproved modifications, or the use of parts not made or approved by the original equipment manufacturer. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE POULAN 260LE




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual POULAN 260LE will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.