User manual POULAN 1420

[. . . ] Veuillez ne pas retourner l'outil au détaillant. 1-800-554-6723 www. poulan. com Instruction Manual Manual de Instrucciones Manuel d'Instructions 1420 1630 ESPAÑOL WARNING: Read and follow all Safety Rules and Operating Instructions before using this product. ADVERTENCIA: Lea el manual de instrucciones y siga todas las advertencias e instrucciones de seguridad. AVERTISSEMENT: Lire le manuel d'instructions et bien respecter tous les avertissements et toutes les instructions de sécurité. Tout défaut de le faire pourrait entraîner des blessures graves. Poulan 1030 Stevens Creek Road Augusta, GA 30907 Poulan 850 Matheson Blvd. [. . . ] OPERATING INSTRUCTIONS Use only a voltage supply as specified on your unit. SELECT AN EXTENSION CORD MINIMUM WIRE GAUGE RECOMMENDATIONS Volts 120 25 ft. (7. 67 m) 16 A. W. G. * BAR OIL CAP/OILER ACTUATOR The BAR OIL CAP is used to access the bar oil tank and pressed to supply oil to chain. CHAIN ADJUSTMENT SCREW The CHAIN ADJUSTMENT SCREW is used to adjust the chain tension. POWER CORD The POWER CORD is used to connect the chain saw to an approved extension cord. CHAIN TENSION It is normal for a new chain to stretch during first 15 minutes of operation. ATTACH THE EXTENSION CORD TO YOUR CHAIN SAW To prevent disconnection from unit, secure extension cord to power cord as shown in the following illustration. Power Cord 50 ft. (30. 48 m) 14 A. W. G. * Extension Cord *American Wire Gauge 7 BEFORE STARTING SAW WARNING: Be sure to read the electrical safety information in the SAFETY RULES section of this manual before you begin. If you do not understand the electrical safety information do not attempt to use your unit. Seek help from someone that does understand the information or call the customer assistance help line at 1-800-554-6723. The manually--operated chain oiler provides lubrication to the chain and guide bar. The oiler activator/bar oil cap must be used regularly and often enough to maintain a thin film of oil on the bar and chain while saw is cutting. It is recommended that the oiler actuator/bar oil cap be operated every ten (10) seconds and held for approximately three (3) seconds each time it is pressed. For maximum guide bar and chain life, we recommend you use Poulan chain saw bar oil. If Poulan bar oil is not available, you may use a good grade SAE 30 oil until you are able to obtain Poulan brand. Discontinue use of the unit until repaired by an authorized service dealer. Connect the saw to a power source using the proper size extension cord (see SELECT AN EXTENSION CORD). Squeeze and hold the trigger switch. CUTTING METHODS OPERATING TIPS S Check chain tension before first use and after 1 minute of operation. Do not cut metal, plastics, masonry, non-wood building materials, etc. Even a small amount of dirt will quickly dull a chain and increase the possibility of kickback. This will help you get the "feel" of using your saw before you begin a major sawing operation. S Squeeze the trigger switch and allow unit to reach full speed before cutting. [. . . ] Hold chain with cutters facing as shown. Tip of Bar CUTTERS MUST FACE IN DIRECTION OF ROTATION 13 Cutters Depth Gauge Drive Links 6. Place chain around the sprocket and fit the drive links into the guide bar groove and then around guide bar nose. Sprocket Bar 8. Secure the guide bar and bar clamp plate with the bar nuts; tighten finger tight only. CAUTION: If saw chain is installed backwards, the saw will vibrate excessively and will not cut wood. [. . . ]