User manual PORT DESIGNS PORT SAFE SMALL DATASHEET

[. . . ] Ventilation To ensure good ventilation, the back panel of the cabinet must be removed. It is advisable to install the oven so that it rests on two strips of wood, or on a completely flat surface with an opening of at least 45 x 560 mm (see diagrams). The appliance must be installed by a qualified person in compliance with the instructions provided. Incorrect installation may cause harm to persons, animals or may damage property. [. . . ] At the beginning of the FAST CLEAN mode, the cooling fan operates at low speed. Once the cooking has been completed, the cooling fan remains on until the oven has cooled down sufficiently. GB Control panel lock To lock the oven controls, press and for 5 seconds. DEMO mode The oven can operate in DEMO mode: all heating elements are deactivated, and controls remain operative. Press again to deactivate the DEMO mode: a buzzer sounds and the two displays show “demo” “off”. Setting the clock and timer or after a blackout, To set the time: After the appliance has been connected to the mains, will begin to blink. Set the time using “+” and “-” on the left side of the control panel 3. Set the minutes using “+” and “-” on the left side of the control panel. To make any changes, turn on the control panel by , then press pressing described above. And follow the steps The timer operates in minutes: when the selected time has elapsed, a buzzer will sound. The buzzer will automatically stop after one minute or when any active symbol on the control panel is pressed. The Rotisserie (only available on certain models) To operate the rotisserie (see diagram) proceed as follows: 1. Place the rotisserie support in position 3 and insert the spit in the hole provided on the back panel of the oven. Mode is on, the rotisserie will stop if the door is 6 Programming your cooking !Set the time using “+” and “-” on the left side of the control panel. When the selected time has elapsed, END appears on the TEMPERATURE display and a buzzer sounds. Press and repeat steps 1 to 2 as described in the Programming Time procedure. When the selected time has elapsed, END appears on the TEMPERATURE display and a buzzer sounds. And a time of 1 hour and 15 minutes is programmed and the end time is set to 12:30. Programming has been set when The CLOCK and COOKING TIME displays show the end time and the cooking time alternately. In the BARBECUE and GRATIN cooking modes, particularly when using the rotisserie, place the dripping pan in position 1 to collect cooking residues (fat and/or grease). MULTI-COOKING • Use position 2 and 4, placing the food that requires more heat on 2. [. . . ] Old appliances must be collected separately in order to optimise the recovery and recycling of the materials they contain and reduce the impact on human health and the environment. The crossed out “wheeled bin” symbol on the product reminds you of your obligation, that when you dispose of the appliance it must be separately collected. Consumers should contact their local authority or retailer for information concerning the correct disposal of their old appliance. Respecting and conserving the environment • By using the appliance in the hours between late afternoon and early morning, you can help reduce the work load placed on electrical companies. [. . . ]