User manual PORT DESIGNS BUNDLES S16 OPTICAL MOUSE WIRED PRODUCT SHEET

[. . . ] ) within the reach of children since these are a source of potential danger. € The appliance must be installed by a qualified technician in compliance with the instructions provided by the manufacturer. € The latter denies all responsibility for improper installation which may harm persons and animals and damage property. € The electrical safety of this appliance can only be guaranteed if the latter is correctly and efficiently earthed, in compliance with regulations on electrical safety. [. . . ] If you have any doubts, call in a qualified technician to check the electrical system thoroughly. € The manufacturer denies all responsibility for damage resulting from a system which has not been earthed correctly. € Before powering the appliance, check whether the technical characteristics featured on the appliance data plate correspond with those of the mains electrical system. € Check that the current load of the mains supply and of the power sockets is suitable for the maximum power of the appliance, indicated on the appliance data plate. Disconnect the appliance from the electricity supply before all operations. Connect your hob to the electrical system by means of a junction box: if the appliance is connected permanently to the mains, an omnipolar circuit breaker, accessible if necessary, with a minimum contact opening of 3 mm should be installed. Valid only for models with a power supply cable Some models are supplied with a single-phase power supply cable, and should consequently only be connected to the singlephase mains. Collegamenti elettrici Tensione Frequenza Fusibili Sezioni To install the cable, proceed as follows: • unscrew the wire clamp screw and the contact screws. € to make the desired electrical connection (see table), use the jumpers housed inside the box. Position the power supply cable wires according to the indications in the table. € once the connections have been made, tighten all the terminal screws fully. To speed up the rise in temperature of the cooking zones (see cooking zone table on the previous page), press the key. When the booster function is on, certain cooking zones (see the cooking zone table on the previous page) are limited to a maximum power of 600W. KBT8424 IDO 400 - KBT8424 IDO - KOT7424 IO KBT6323 IO: you may programme all the cooking zones simultaneously for a maximum cooking time of 99 minutes. Proceed as follows: • select the cooking zone by pressing the corresponding control key, • set the desired heating power using the “+” and “-” keys, • press the programming key , • set the desired cooking time using the “+” and “-” keys, • confirm your programming by pressing the programming key again. The end of programmed cooking is signalled by a beep (one minute long) and the cooking zone concerned is turned off. The safety devices Pan recognition Each induction cooking zone is fitted with a pan recognition device. The cooking zone only provides heat in the presence of a pan which is suitable for the cooking zone. A blinking pan recognition indicator could signal: • that the pan is made of unsuitable material, which is not ferromagnetic, • that the diameter of the pan is too small, • that the pan has been removed. To avoid any interference between your induction hob and a pacemaker, the latter must be designed to comply with relevant regulations. Please consult the pacemaker manufacturer or your doctor concerning its conformity or any possible incompatibility. To use the hob, turn it back on and re-select the cooking zone(s) you wish to use. [. . . ] € Do not use steam cleaners or high pressure cleaners to clean your appliance. € Do not place metal items on the hob (such as knives, spoons, lids, etc. The guarantee does not cover damage to the hob caused by incorrect use. € Always use pans whose diameter covers the cooking zone fully so that all the available heat can be used. [. . . ]