User manual POLYCOM PTB410 REV C

[. . . ] Link Wireless Telephone and Accessories Model PTB400/410 Model PTB450 Link Dual Charger Link Quick Charger Link Quad Charger User Guide Part Number: 72-0075-09 Issue C SpectraLink Corporation Link Wireless Telephones and Accessories User Guide Trademark Information Polycom® and the logo designs SpectraLink® LinkPlus Link NetLink SVP Are trademarks and registered trademarks of Polycom, Inc. All other trademarks used herein are the property of their respective owners. Notice Polycom, Inc. has prepared this document for use by Polycom personnel and customers. The drawings and specifications contained herein are the property of Polycom and shall be neither reproduced in whole or in part without the prior written approval of Polycom, nor be implied to grant any license to make, use, or sell equipment manufactured in accordance herewith. [. . . ] The Link Quad Charger may be mounted on a horizontal or vertical surface. Power supply The power supply that is required for this unit is the SpectraLink part number GCX100A. Set up the Link Quad Charger by plugging the power supply into the Link Quad Charger and into an appropriate wall outlet. A solid red LED above an empty charger slot indicates that the slot is idle and ready for use. If the LEDs do not light, check the power supply and plug connection to the charger. If the charger appears to be plugged in correctly, make sure the wall outlet has power. Position the Battery Pack in a charging slot by aligning the top of the Battery Pack with the tracks on the charging slot then gently sliding the Battery Pack upward onto the charging slot. While the Battery Pack is in the charging slot, the LED above the slot will indicate the status of the charging process and/or the Battery Pack. The Link Quad Charger takes 60-90 minutes to fully charge a Battery Pack. If the NiMH Battery Pack is hot or cold when placed in the charger, it may take longer to charge. However, if you remove a fully charged Battery Pack then replace it in the charger, the charger LED will be solid green until the charger determines that this Battery Pack is fully charged. Solid red or flashing red--the Battery Pack in the charger is no longer capable of retaining a charge and is not usable. If the Battery Pack will not charge, do not continue to charge the Battery Pack. Dispose of it properly and do not attempt to use it in the wireless telephone. Do not attempt to open or repair a defective Battery Pack. Part Number: 72-0075-09-C. doc Page 15 SpectraLink Corporation Link Wireless Telephones and Accessories User Guide Flashing red/green--there is a problem with either the Battery Pack or charger. Allow the Battery Pack to stabilize at room temperature and try again. If the Battery Pack will not charge, do not continue to charge the Battery Pack. Dispose of it properly and do not attempt to use it in the wireless telephone. If several different Battery Packs cause the charger to show a flashing red or red/green LED, the charger may not be working properly. To verify this, check the Battery Pack in a different slot or substitute another charger and repeat the operation that caused the failure. If the same Battery Pack lights a green LED when inserted in a different slot or charger, the first charger is faulty. Contact your service representative for assistance. Part Number: 72-0075-09-C. doc Page 16 SpectraLink Corporation Link Wireless Telephones and Accessories User Guide General Care of the Wireless Telephone and Chargers Do not drop This section applies to all Link Wireless Telephones and all Link chargers. [. . . ] Privacy of communications may not be ensured when using this telephone. Chargers PTQ360, PTC400, BC4900 This Class A digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe A est conforme à la norme NMB-003 due Canada. International Certifications United States Canada 3 UL 60950 CAN/CSA-22. 2 No. 60950 United States Part 15 TUV Rheinland of North America is a Nationally Recognized Testing Laboratory (NRTL) in the United States and is accredited by the Standards Council of Canada to test and certify products to Canadian National Standards. and Canadian markets through a single mark (cTUVus) on their product(s) which denotes compliance to U. S. [. . . ]