User manual POLYCOM KIRK 7020 QUICK GUIDE

[. . . ] Pair Wireless Headset with the Handset 5 Select the headset code number listed in the display of the handset and press Stop, then press Add. The wireless headset will now connect automatically to the handset when the headset is turned on. When the headset is active and the handset is off hook, the audio can be switched between the headset and the handset. 1 Activate handset / headset soft key by pressing the left or the right side of the navigation key. [. . . ] Do not use the telephone to report a gas leak in the vicinity of the leak. Do not place the base or charger near microwave ovens, radio equipment, or non-ground connected televisions. These appliances may cause electrical interference to the base or handset. The charger must be placed on a hard, flat surface and connected to a functional 120 volt AC power source depending on the country of use. Installation must be performed in accordance with all relevant national wiring rules. Plug acts as Disconnect Device - The socket outlet to which this apparatus is connected must be installed near the equipment and must always be readily accessible. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter. Do not use the handset in conditions where there is a danger of electrically ignited explosions. Exposure to sunlight, heat and moisture Do not expose the wireless phone to direct sunlight for long periods. Spare parts and accessories Use only approved spare parts and accessories. The operation of nonapproved parts cannot be guaranteed and may even cause damage. Power failure In the event of a power failure or flat battery, you cannot use the handset to make or receive calls. Periodically clean the charge contacts on both the charger and handset. Exercise care in handling batteries in order not to short the batteries with conducting materials such as rings, Released electrolyte is corrosive and may cause damage to the eyes or skin. Dispose of used batteries according to the manufacturer's instructions. Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local telecommunications company. The equipment must also be installed using an acceptable method of connection. The customer should be aware that compliance with the above conditions may not prevent degradation of service in some situations. repairs to certified equipment should be coordinated by a representative designated by the supplier. Any repairs or alterations made by the user to this equipment, or equipment malfunctions, may give the telecommunications company cause to request the user to disconnect the equipment. Users should ensure for their own protection that the electrical ground connections of the power utility, telephone lines and internal metallic water pipe system, if present, are connected together. EMC CAUTIONS: Users should not attempt to make such connections themselves, but should contact the appropriate electric inspection authority, or electrician, as appropriate. [. . . ] These guidelines are based on the safety standards previously set by international standard bodies. These standards include a substantial safety margin designed to assure the safety of all persons, regardless of age and health. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter. IC Note: Operation is subject to the following two conditions: (1) This device May not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. [. . . ]