User manual POLTI VAPORETTO POCKET

[. . . ] · Do not allow the power cord to be twisted, crushed, stretched, or come into contact with sharp or hot surfaces. · Do not use the appliance if the power cable or other important parts are damaged. · Do not use electric extension leads that are not authorized by the manufacturer, as they may cause damage or fire. · If it is necessary to replace the power supply cable, please refer to the nearest Polti authorised service centre, since the use of a special tool is necessary. [. . . ] Otherwise the still hot boiler walls can spit drops of very hot water or steam spray. · Do not put any detergent or chemical substance in the boiler. · Make sure the patented safety cap is fully and correctly screwed on, otherwise you may experience very hot steam escaping from around the cap. · Do not empty the appliance when the water in the boiler is still hot. · Do not try to unscrew the safety cap when the appliance is in use. · Check the safety cap and that the related inner gasket is present, replace them with original spare parts if necessary. · This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. 27 ENGLISH ATTENTION: Danger of burns! VAPORETTO POCKET (13) into the two eyelets (G) (Fig. 3). Open the door of the one-piece socket (E); insert the moulded plug (3) until a click is heard (Fig. To release the sheath, simply press the release key (E1) and at the same time remove the moulded plug (3). The ON lamp (C) and the steam pressure indicator lamp (D) will both light up. Wait for the pressure indicator lamp (D) to extinguish (about 10 minutes). The steam sprayer (2) has a safety button (2A) that prevents accidental activation of the steam delivery system by a child or other persons unaware of how the device works. To resume delivery press the button (2A) in the opposite direction and operate the steam control lever (4) (Fig. The first jet of steam may contain some water droplets, due to imperfect thermic stabilisation inside the flexible hose. We would therefore advise that the first jet of steam is played onto an old cloth until a constant steam flow is obtained. Note: The steam pressure indicator (D) may go on and off from time to time during use of Vaporetto, this is quite normal VERY IMPORTANT WARNING: If you press the steam request lever (4) when the appliance is still under pressure, even if it is off and not connected to the wiring system, you may still experience steam escaping from the flexible hose. So when you switch off the appliance, before storing it, it is neccessary to press the lever (4) till the steam flow is exhausted. CONNECTION OF ACCESSORIES · To connect the extension tubes (7) to the grip, the large brush (8) and the adapter (5), simply join them to one another until the accessory locking button (11) clicks into place (Fig. · To release the accessories simply hold the button (11) down and separate the components (Fig. · Before using the accessories, make sure that they are firmly in place. WARNING: To connect the accessories (6) and (12), it is necessary to fasten the adapter first (5). Once the adapter is secured in place, block the accessory and lock it by turning it in the direction of the arrow on it (Fig. 7). [. . . ] 6B - Small round brush and 6C - Large round brush: suitable for removing caked dirt from very narrow surfaces such as cooker burners, roller shutters, joints between tiles, sanitary fixtures, etc. It is possible to choose the most suitable brush depending on the size of the surface to be cleaned. To connect accessories 6A-6B or 6C to the lance (6), simply fit these accessories onto the tip of the lance exerting a slight pressure (Fig. 9). T R A N S P O RT One of the great advantages of this device is that it can be carried anywhere, thanks to the handle (H) or the shoulder strap (13). [. . . ]