User manual POLTI VAPORELLA AL PROFESSIONAL

[. . . ] Steam button Monotube (cable + steam tube) Steam pressure warning lamp Power cable Patented safety cap Funnel Cable stand Removable iron rest Iron switch Iron temperature adjustment Boiler switch Before leaving the factory, all our products are subjected to rigorous testing. [. . . ] 5) Wait for the Steam Pressure warning light (3) to go out, then press the button (1) on the iron to control the emergence of steam from the sole plate (Fig. Continue ironing as normal even if the warning lamp comes on and goes out, this indicates the iron is working correctly. When the iron is no longer delivering steam, switch off the boiler switch (11), open the patented safety cap (5), wait 2-3 minutes for the boiler to cool down, and then refill it. â· During initial operation of the iron, a few drops of water mixed with steam may come out of the soleplate since the temperature has not yet perfectly stabilized. It is advisable not to direct the first jet onto the fabric to be ironed. â· Make sure that the patented safety cap (5) is screwed down correctly, otherwise steam leaks could occur. â· The device is fitted with a safety temperature limiter, which should only be replaced by an authorized engineer. â· When repairing or replacing any component, and in particular the special safety cap, only use original parts. [. . . ] Perfect ironing is dependent on these two characteristics: the suction which locks the garment on the board, so preventing the formation of annoying wrinkles which are so difficult to eliminate on conventional ironing boards, and the heated board which dries the fabrics and makes ironing easier, faster and less laborious. [. . . ]