User manual POLTI STIRA E ASPIRA LUX

[. . . ] LEGEND 1) Ironing surface 2) Opening handle 3) Vaporella supporting-grill 4) On/off switch 5) Suction switch 6) Supply cable storage 7) Supply socket for ironing stations (Continental plug only) 8) Supply cable 9) Flex holder 10) Band for fixing legs to underside of board Power supply: 220V / 240V ­ 50 Hz 400 W 100 W max 10 A - 230 V Heated board power: Aspiration power: Socket for iron: Dimensions of closed board Weight Pull the opening handle (2) upwards and open the board (1), supporting it as it rises to the right height position. [. . . ] Wait for about 5-6 minutes to allow the ironing surface to reach the operating temperature. It will allow you to hold the clothes on the board and to eliminate the residual humidity. Note: it is important to always use the aspirator while you use the steam iron in order to avoid the formation of water condensation inside the ironing board. Pull the opening handle (2) and support the board (1) as it descends to the floor. 4 Rewind the supply cable (8) to its storage (6) as shown in figure (5) The ironing board can now be stored. In case of damage of malfunction, do not try to disassemble the appliance but address to the authorised Polti After-Sales Service nearest to you. [. . . ] The supply cable must be replaced by the manufacturer or its After-Sales Service, so as to prevent any risk. [. . . ]