User manual POLTI STIRA E ASPIRA

[. . . ] 5 6 ENGLISH Stira e Aspira LEGENDE 1) Ironing surface 2) Opening handle 3) Vaporella supporting-grill 4) On/off switch 5) Suction switch 6) Supply cable storage 7) Supply socket for ironing stations (Continental plug only) 8) Supply cable 9) Flex holder 10) Band for fixing legs to underside of board Stira e Aspira ENGLISH OPENING 1. [. . . ] Pull the opening handle (2) and support the board (1) as it descends to the floor. 4 Rewind the supply cable (8) to its storage (6) as shown in figure (5). The ironing board can now be stored. WA R N I N G · In case of damage or malfunction, do not try to disassemble the appliance but address to the authorised Polti After-Sales Service nearest to you. The supply cable must be replaced by the manufacturer or its After-Sales Service, so as to prevent any risk. · ATTENTION: if you iron sitting down, do not place your legs under the ironing board, the steam can cause burns. ENGLISH Stira e Aspira FOR YOUR OWN SAFETY READ FOLLOWING INSTRUCTIONS CAREFULLY BEFORE ATTEMPTING TO CONNECT THIS UNIT TO THE MAINS. M A I N S ( A C ) O P E R AT I O N This unit is designed to operate on 240V, 50 Hz current only. This appliance may be fitted with a non rewirable plug, if it is necessary to change the fuse in a non rewirable plug the fuse cover must be refitted. If the fuse cover is lost or damaged, the plug must not be used until a replacement, available from the appliance manufacturer, is obtained. It is important that the colour of the replacement fuse cover corre-sponds with the colour marking on the base of the plug. [. . . ] The wire which is coloured brown must be connected to the terminal which is marked with the letter "L" or coloured red. [. . . ]