User manual POLTI RAFFAELLO INSTRUCTIIONS FOR USE

[. . . ] AROMA RAFFAELLO Dear Customer, Thank you for choosing a Polti product. With this coffee machine, you will enjoy full taste and aroma right from the first cup and make creamy cappuccino as well as tea and other hot drinks. AROMA RAFFAELLO is made with top quality components to ensure quality and perfect safety. Please read these instructions carefully before using AROMA RAFFAELLO. MACHINE CONTROLS AND COMPONENTS 1. [. . . ] If this happens, press the button (7) to conduct another short rinse cycle through the coffee outlet (8). IMPORTANT: The system must be programmed either for use of a water filter or for the hardness of the water and therefore the manual lime scale removal cycle. If you are using the filter on the machine and the system is programmed to "On", water hardness and manual lime scale programming cannot be displayed. Follow the instructions in the section on "replacing the water filter" to replace it. Important: If you have not used the machine very much, you must replace the filter even if no indication appears on the display after a maximum of two months (see the section on "manual filter replacement (25)"). As a reminder, you may set the replacement date on the wheel on the top of the filter. For more thorough prevention of lime scale build-up, you should run the "lime scale removal" programme at least once a year even if you regularly use the resin-based filter. Without filter If you no longer want to use the filter, you must reprogramme the filter setting to "OFF". This is important as you must use the lime scale removal programme if you are not using the filter. Press the service button (7) for about 2 seconds to enter Programming mode. Press the selector (4) until only the is flashing, indicating that the filter has been excluded (Filter OFF). Don't forget to programme water hardness when not using the filter. WATER HARDNESS The frequency of lime scale removal depends on the hardness of your local water supply. Set water hardness correctly as soon as you begin using the machine so that the system will be able to inform you when the lime scale procedure is necessary. First test the water using the litmus paper (26) supplied: Fill a small container with tap water. Dip the litmus paper into it and remove it immediately, then shake it gently. After about one minute you will be able to read the results by counting the red dots. Different levels are distributed as shown below: ­ ­ ­ ­ 1 red dot = 1 -7° dH / 1 - 12. 6 °fH 2 red dots = 8 -14° dH / 12. 7 -25. 2 °fH 3 red dots = 15-21° dH / 25. 3-37. 8 °fH 4 red dots = > 21° dH / > 37. 8 °fH = = = = . ENGLISH When no red dots are visible, set the 1d. Press the service button (7) for about 2 seconds to go to Programming mode. The symbols will come on in sequence (The water hardness symbol will not appear if the filter is set to "On"; refer to the "FILTER" section). Wait until the symbol comes on and confirm by pressing the selector (4). Wait until the filter symbol press the selector (4). symbols will start flashing. AROMA RAFFAELLO 6d. [. . . ] This appliance may be fitted with a non rewirable plug, if it is necessary to change the fuse in a non rewirable plug the fuse cover must be refitted. If the fuse cover is lost or damaged, the plug must not be used until a replacement, available from the appliance manufacturer, is obtained. It is important that the colour of the replacement fuse cover corresponds with the colour marking on the base of the plug. If the plug requires to be changed because it is not suitable for your socket, or becomes damaged, it should be cut off and an appropriate plug fitted following the wiring instruction (below). [. . . ]