User manual POLTI DRYER FA 110

[. . . ] This also saves energy, as the appliance starts operating only when it is necessary to restore the correct humidity. By turning the "HUMIDIFY SETTING" knob on the "CONT. " position, the automatic stopping device is in fact excluded and the appliance operates continuously. [. . . ] · Never immerse the appliance in water or any other liquid. O P E R AT I O N · DRYER FA 110 is able to operate properly in places where temperature is included between 5 and 35°C. Outside this range, the protection device of the compressor will stop the operation of the appliance. · If the dehumidifier does not start, check that the set humidity required is not higher than the humidity in the room. · If the dehumidifier does not start or it stops working, check the appliance is correctly connected. If the plug and power supply are OK, wait for about 10 minutes (the automatic safety cut out takes about 10 minutes to respond) and restart the appliance. If the appliance still does not work, contact your authorised Polti Service Centre. ENGLISH · When the DRYER FA 110 is in operation, the compressor will produce heat and the room temperature could become slightly higher. · Close all the doors and windows when the appliance is in operation to obtain better dehumidifying results. INSTRUCTIONS To start the dehumidifier: 1. Put the humidity control knob on the "OFF" position, turning it to the left. Start the dehumidifier by turning the humidity control knob (D) to the right, and set it to the desired humidity (normally on position 7, corresponding to RH60%). When the compressor is in operation, the green indicator light (C) comes on. To turn off the dehumidifier, turn the humidity control knob to the left on position "OFF". SUGGESTED HUMIDITY SETTINGS The range of relative humidity corresponding to the numbers on the humidity control knob is the following: Control knob position nr. 1 3 5 7 9 Approx. humidity regulation 20% 30% 40% 60% 80% For living-rooms, dining-rooms and bedrooms we suggest position "7". [. . . ] · It is recommended to clean the filtering net at least once every two weeks of operation, simply using some water with temperature lower than 40°C. · To avoid deformation, let the filtering net dry away from heat sources such as sun, stoves, heaters etc. [. . . ]