User manual POLTI DRYER FA 100

[. . . ] When the tank is full, the appliance stops operating and the water level indicator (TANK FULL) lights up. When the room temperature is lower than 12°C, the device automatically starts operating for 8 minutes every hour. During this operation mode the "DEFROST" indicator light lights up. I N S TA L L AT I O N · Before connecting the unit to the mains, make sure that the power supply corresponds to the one specified on the technical details labels. [. . . ] · Do not place the appliance near heat sources such as stoves, heaters etc. · Keep the areas behind and in front of the unit clear from obstruction, so that the air flow is not hindered. · Avoid putting water containers, watered plants, or heavy objects on the unit. ENGLISH PRECAUTIONS · Read the operating instructions carefully before using your dehumidifier for the first time and keep them for future reference. · Use the appliance only for domestic use and only for the purpose it was designed for. · Never operate the appliance if it has been subjected to violent knocks, if it is damaged or if a malfunction has caused damage to the electrical connections. · Do not allow children or people who are not familiar with the instructions to use the appliance. · Disconnect the appliance from the mains when it is not in use, before moving it and before cleaning it. · To avoid spillage, empty the water tank before moving the appliance. During this functioning mode the "DEFROST" indicator light comes on. WAT E R L E V E L I N D I C AT O R · DRYER FA 100 is equipped with a water level indicator: when the water storage level becomes full, the compressor and the fan stop and the red indicator light "TANK FULL" lights up to signal the necessity to pour out the water from the storage tank. H O W T O E M P T Y T H E WAT E R S T O R A G E TA N K · Take out the water tank by gently pulling it outwards, through the hollow at the base of the tank (fig. · Empty the tank and gently place it back in the unit, paying attention that it reaches the correct position. If the tank is not in the correct position, the compressor will not start. · When the unit stops it is necessary to wait for about 3 minutes before starting it again. This waiting time has been factory-set to protect the compressor from damage. · Therefore, it is suggested not to remove and replace the tank repeatedly, as these actions involve a repeated start of compressor with consequent risk of wear and malfunction. Fig. 1 ENGLISH U S E O F C O N T I N U O U S WAT E R D R A I N · Take out the water tank by pulling it outwards. · With a tool remove the cover of the hole for direct condensation drainage, which is at the back of the unit (fig. [. . . ] in the drainage hole and connect it to the drainage mouth at the front of the unit (fig. Important: make sure that the continuous drainage pipe is connected to a suitable drainage in order to prevent the liquid from spilling on the floor. SUGGESTIONS FOR GENERAL MAINTENANCE · The appliance is equipped with an extractable and Fig. To take out the filter it is enough to slip it off by pulling it downwards (fig. [. . . ]