User manual POLTI CAPPUCCINO 1000

[. . . ] â· Do not touch the appliance with wet hands or feet when it is plugged into the mains. â· Do not place the appliance in water or in any other liquid. â· Unplug the appliance before performing any maintenance. [. . . ] Correctly replace the tray in its housing paying attention that the suction tube is correctly positioned. Fill the container (15) with cold milk as previously described in point VI and VII of the "Instructions for use" paragraph. â· Turn the knob (8) anticlockwise, towards the indicator , the pilot light (7) switches on. A dose of coffee is installed and the milk is drawn up to dispense an excellent cappuccino. Do not worry if you do not hear any noise after turning the selection knob (8); the machine prepares your CAPPUCCINO silently. When the desired amount of milk is reached, turn the knob (8) back to the initial position, indicated with "w". Wait a few seconds after the pilot light (7) switches off before withdrawing the cup to collect all the milk in the tube. Fill the container (15) with cold milk as previously described in point VI and VII of the "Instructions for use" paragraph. â· Turn the knob (8) clockwise, towards the indicator , the pilot light (7) switches on and the milk will pour into the cup in just a few seconds. When the milk inside the cup reaches the desired amount, turn the knob (8) back to the initial position indicated with "w". Wait a few seconds after the pilot light (7) switches off before withdrawing the cup to collect all the milk in the circuit. To prepare a good hot chocolate drink, add two teaspoons of soluble hot chocolate powder to the empty cup and then perform the same operations described in the "Preparing whipped milk" paragraph. Before switching the machine off after use, clean it following the instructions below. â· Do not switch off or disconnect the machine before the pilot light (7) is off. â· Rinse the milk container (15), fill it with water and replace it in its housing. â· Place an empty container over the liquid collector grill and perform the dispensing operation by turning the knob (8) clockwise towards the indicator until the equivalent of a cup full of hot water pours out. By allowing water to pass through the circuit, a self-cleaning operation is performed which eliminates any residual milk. (NECESSARY AFTER ABOUT 20/30 DISPENSINGS) It is necessary to periodically clean the coffee measure unit. [. . . ] aTTENTION The appliance is built according to the current recycling rules. It is recommended not to throw away the transport protection packing materials, but take them to the relevant collection centre. TROUBLE The dispensing does not start or it stops Turbulent dispensing with steam output Failure to dispense coffee CAUSE Lack of water in the container (4) The milk or water are not cold enough Lack of coffee in the container. [. . . ]