User manual POLTI VAC 160

[. . . ] KEY On/off switch with indicator light Carrying handle Pleated filter cover Opening lever of the pleated filter cover Pleated filter (note: dashed line) Closing latches Cable-winder Cover with motor group Cover grill for air outlet filter Air outlet filter Waste container Accessories storage Pivoting wheels Power supply cable A. This unit conforms with EC-directives 89/336 as amended by 93/68 (EMC) and 73/23 as amended by 93/68 (low voltage). [. . . ] Pull the closing latches (4) outwards and at the same time lift the cover with motor group (6) upwards (fig. Place the cover with motor group (6) on the waste container (9) and close it with the two closing latches (4). NOTE: Small pieces of dry dirt can be vacuumed even without dust bag (G). Prepare the appliance as described in the PREPARATION FOR USE paragraph, then unwind the supply cable (12) and connect it to the mains. Before maintenance, make sure that the supply cable is not connected to the mains. control of the float · After vacuum cleaning liquids, it is suggested to empty the waste container (9). ⷠPull the two closing latches (4) outwards and at the same time lift the cover with motor group (6) (fig. 6) · Empty the sucked up liquid from the waste container (9). ⷠCheck that the float (M) is not dirty and that it has no obstructions, if necessary clean before operating (fig. Pull the two closing latches (4) outwards and in the meantime lift the cover with motor group (6) (fig. Remove the dust bag (G) from the two pins (L) · Replace it with a new one by fitting it as explained in the DRY-VACUUMING paragraph. replacing the pleated filter · Push the opening lever of the pleated filter cover (3a) and then pull it upwards. [. . . ] This way the joint is showing and it will allow to change the angle of operation of the tubes fig. When the operations are over, put the joint back in its original position, cover it with the slide ring and turn it to lock into position. [. . . ]