User manual POLK AUDIO T15

[. . . ] " To allow Polk Audio to offer the best possible warranty service, please fill out the Product Registration Card(s) and send it to the Factory, at the address provided on the Product Cards(s) within ten (10) days of the date of purchase. Defective Products must be shipped, together with proof of purchase, prepaid insured to the Polk Audio Authorized Dealer from whom you purchased the Product, or to the Factory at 2550 Britannia Boulevard, Suite A, San Diego, California 92154. Products must be shipped in the original shipping container or its equivalent; in any case the risk of loss or damage in transit is to be borne by you. [. . . ] This Warranty gives you specific legal rights, and you also may have other rights which vary from state to state. This Warranty applies only to Products purchased in the United States of America, its possessions, and U. The Warranty terms and conditions applicable to Products purchased in other countries are available from the Polk Audio Authorized Distributors in such countries. Polk Audio, Polk, PowerPort, Dynamic Balance, F/X, Atrium, Big Speaker Sound Without The Big Speaker, High Velocity Compression Drive, Acoustic Resonance Control, ARC Port, Casket Basket, I-Sonic, SurroundBar & SDA are registered trademarks of Britannia Investment Corporation used under license by Polk Audio, Incorporated. Polk Audio Designs & miDock are trademarks of Britannia Investment Corporation used under license by Polk Audio, Incorporated. Do not insert insulated section of wire into hole (you will not get a connection). When wall mounting, we recommend using either bare wire or spade lug connections to ensure flush mounting. Wall mounting requires basic skills with tools such as a drill and a screwdriver. If you are in doubt that you possess the necessary skills or tools, consult your Polk Audio dealer, or a professional installer. Make sure the material on which you plan to mount the speakers (plaster, drywall, paneling, stone, etc. Make sure the locations you select do not conceal electrical wiring or plumbing. The slot appears centered approximately 3 1/4" from the left corner of the T15. Use these measurements to mark to your mounting location, being sure to leave approximately 1-2" of clearance above the speaker to compensate for the function of the keyhole slot. If you are certain that there is a stud behind the wall surface, drive #10 sheet metal screws · If there is no stud behind the wall at the chosen location, install #10 wall Anchors (not supplied) into the wall by following the wall-anchor-manufacturer's instructions. Tighten screws into stud or wall anchors, leaving screw heads protruding 1" - 2" to leave room for attached wire and ensure that the screw fits into the keyhole slot. Line up the keyhole slot so that the screw head passes through the large center hole of the slot. [. . . ] Pour obtenir la meilleure image stéréophonique, disposez les enceintes de façon à ce que la distance qui les sépare soit la même que la distance qui les sépare de votre point d'écoute. Si la distance entre les enceintes doit être plus grande que leur distance du point d'écoute, dirigez-les vers ce point pour obtenir une image centrale plus précise. You can use T Series speakers as rear surround speakers in a Polk Audio home theater system. [. . . ]