User manual POLK AUDIO RM4600

[. . . ] G E T T I N G S TA RT E D Make certain your system contains all its parts: The complete RM7200 comes in ONE carton, containing the following items: Four (4) magnetically shielded micro-satellite speakers with integrated wall mount brackets One (1) magnetically shielded micro-center channel speaker with integrated wall mount bracket One (1) RM7200 8" Powered Subwoofer The complete RM7600 comes in TWO cartons. Carton 1 contains the following items: Four (4) magnetically shielded satellite speakers with integrated wall mount brackets One (1) magnetically shielded center channel speaker with integrated wall mount brackets Carton 2 contains the following item: One (1) PSW series powered subwoofer with instruction manual Please inspect each loudspeaker carefully. Notify your Polk Audio dealer if you notice any damage or any missing items. They will do the best job of protecting your speakers if they need to be transported. [. . . ] Tug gently on the speaker to make certain that the screws and bracket are properly aligned and that the wall anchors are secure. If the bracket is not held snug against the wall by the screw heads, remove the speaker from the wall, drive the screws in a little further and then remount the speaker. We recommend the following settings as starting points, but the settings that are best for you depend upon your speaker placement, electronics and personal taste. After you've become familiar with what the settings do, experiment with alternate options to find the method that works best for your system setup. R M 7 2 0 0 A C P O W E R (Figure 13) The RM7200 Powered Subwoofer has a built-in power amplifier and must be plugged into a standard household AC power source in order to operate. The power switch has three positions: "On, " "Off" and "Auto" (Figure 13). When the Powered Subwoofer is plugged in (even with the power switch in the "off" position) the power light will glow RED. Turning the knob down from the recommended setting will make the bass and lower midrange sound "thinner. " RM7200 PHASE SWITCH Changing the phase of your subwoofer can strengthen its bass "attack. " If the bass sounds muddy or unclear, try toggling the phase control. Have someone else switch between the two settings while you sit in your favorite listening position. Use music with good bass (preferably "plucked" string bass) and a deep male vocal. When you hear the best balance of deep bass and natural lower octaves of the male voice, you have achieved optimum phase tuning. We recommend the following settings as starting points, but the settings that are best for you depend upon your speaker placement, electronics and personal taste. After you've become familiar with what the settings do, experiment with alternate options to find the method that works best for your system setup. Outside the US: These adjustments are specific to the Polk Audio PSW650 Model Subwoofer. If you are using a subwoofer other than the PSW650, please refer to that subwoofer's owner's manual for correct, model-specific adjustment instructions You'll find an informative article on "Subwoofer Positioning and Adjustment" in the set up section at http://www. R M 7 6 0 0 A C P O W E R (Figure 14) The RM7600 Powered Subwoofer has a built-in power amplifier and must be plugged into a standard household AC power source in order to operate. The power switch has three positions: "On, " "Off" and "Auto" (Figure 14). The Powered Subwoofer also has a small GREEN light under the Level Control Pod on the subwoofer's front face. This light is not illuminated when the Subwoofer power switch is in the "Off" position. In the "Auto" position, the amplifier will automatically turn on as soon as the speaker senses a signal coming from your electronics. [. . . ] RM3600 Center RM7200 Subwoofer RM7200 System RM4300 Satellite RM4600 Center 80Hz-23kHz 115Hz-20kHz 80W NA 20-125W 20-125W 20-125W NA 32Hz-180Hz 32Hz-20kHz 90Hz-25kHz 80Hz-25kHz 28 - 125 Hz 26Hz-200Hz 26Hz-23kHz 65Hz-26kHz 55Hz-26kHz 25 - 180Hz 25Hz-26kHz 28Hz-25kHz 20 -150 Watts/channel 89dB SPL NA NA 89dB SPL 89dB SPL NA 89dB SPL 8 ohms NA NA Compatible with 8 Ohm outputs NA NA Compatible with 8 Ohm outputs NA Compatible with 8 Ohm outputs 165 W Continuous Average Power into 4 Ohms with < 1% THD, 30-200Hz NA (see specification in subwoofer manual for power rating) NA 100W Contiuous Average Power into 4 Ohms with < 1% THD, 30-200Hz NA NA 5. Selectable 80Hz High Pass Filter on the line level outputs vented vented with floorcoupled Power Port NA vented vented Power Port, vented (see individual component's specs) 11 1/4" H x 9 13/16" W x 5 1/2" D (28. Warrants to the original purchaser only that this Polk Audio Loudspeaker Product (the "Product") will be free from defects in materials and workmanship for a period of five (5) years from the date of original retail purchase from a Polk Audio Authorized Dealer. However, this Warranty will automatically terminate prior to the expiration of the five (5) years if the original retail purchaser sells or otherwise transfers the Product to any other party. [. . . ]