User manual POLK AUDIO MM691

[. . . ] The lower number indicates the lowest continuous rated power that will yield acceptable performance in a typical listening environment. The higher number indicates the highest per channel power that should be used with your Polk speakers. That number should not be confused with a "Power Handling" specification and it does not imply that the speaker will safely handle that full amount of power on a long-term basis. We specify a wide range of power ratings because not all electronics manufacturers use the same method for rating power. [. . . ] Should you isolate the problem to the loudspeaker, contact the authorized Polk Audio dealer where you made your purchase, or contact Polk Audio Customer Service 800-377-7655 (M-F, 9-6 EST, US only) or via email polkcs@polkaudio. More detailed information--including audio how-to articles, FAQs, and online manuals--is available on our award-winning website: www. Figure 8 INSTALLING MM651/MM6501 WITH GRILLE Some applications may require using the additional spacer/adapter bracket. Figure 8 INSTALLATION: MM651/MM6501 avec grille En certains cas, un support adaptateur-espaceur pourrait être requis. ABSTANDSRING-ADAPTER (nur für die MM651/MM6501Treiber-Installation) STAFFA DI ADATTAMENTO/DISTANZIATRICE (solo per l'installazione del driver MM651/MM6501) ESPAÇADOR/SUPORTE ADAPTADOR (apenas para instalação dos modelos MM651/MM6501) Figure 10 TWEETER ATTENUATION SWITCH A 2-position switch (-3dB, 0dB) allows you to adjust tweeter level for the tonal balance that's right for your car and system. Route wires through the cutout and then through the round opening in the bottom of the cup. Press the flush cup/spring clamp assembly into the cutout until the spring clamp arm's snap into place. Connect wires from the tweeter terminals for the crossover to the tweeter itself using the faston connectors. Connect the red wire from the (+) positive terminal of the crossover tweeter output to the red positive (+) wire from the tweeter. Using the base of the surface mount cup as a template, mark the screw hole and drill them using a 1/8" (3mm) drill bit. Drill a second hole (for the speaker wire) using a 3/16" (5mm) drill bit. Push the tweeter wires through the open area at the bottom of the cup and through the 3/16" (5mm) hole in the panel. Connect wires from the tweeter terminals of the Crossover to the tweeter wires using faston connectors. Be sure to connect the red wire strand from the tweeter to the (+) terminal of the crossover tweeter output. Polk Audio loudspeakers and subwoofers are capable of playing at extremely high volume levels, which could cause serious or permanent hearing damage. Accepts no liability for hearing loss, bodily injury or property damage resulting from the misuse of its products. Keep these guidelines in mind and always use your own good judgment when controlling volume: · High volume in an automobile can hinder your ability to safely operate a vehicle. You are responsible for knowing the local laws governing acceptable mobile volume levels. Html Product Disposal - Certain international, national and/or local laws and/or regulations may apply regarding the disposal of this product. For further detailed information, please contact the retailer where you purchased this product or the Polk Audio Importer/Distributor in your country. [. . . ] Be liable to you for any incidental or consequential damages arising out of the use or inability to use the Product, even if Polk Audio, Inc. Or a Polk Audio Dealer has been advised of the possibility of such damages, or any other claim by any other party. Some states do not allow the exclusion or limitation of consequential damages, so the above limitation and exclusion may not apply to you. This Warranty gives you specific legal rights which may vary from state to state. [. . . ]