User manual POLK AUDIO MM6

[. . . ] The benefit of Dynamic Balance is the dramatic improvement in the sound quality of our speakers, which every listener can appreciate. You no longer have to choose between excellent bass and smooth, clear midrange and highs. You'll love the way Polk Audio speakers sound in your living room!Whether you desire audiophile-quality sound for your home, car or even your multimedia computer, Polk loudspeakers deliver unmatched performance and value. [. . . ] Use the speaker grille as a template for marking the locations of the four screw holes. Cut the supplied driver wire (the heavier gauge of the two sets of wire) in half. Attach the wire with the white stripe to the positive (+) terminal screw, and the un-striped wire to the negative (-) terminal screw. Route the driver wire from the crossover location through grommets to the mid/woofer location. Strip 1/8" ­ 1/4" (4-6 mm) of plastic insulation from the cut ends of the driver wire. Unscrew the binding post thumbnuts on the mid/woofers to fully expose the hole in the terminal shaft and slip the other end of the wire into the holes in the input terminals. Tighten the thumb nuts fingertight (do not over-tighten the nuts as you may strip the threads). Be sure to attach the wire with the white stripe to the positive (red) terminal, and the unstriped wire to the negative (black) terminal. Place the grille over the driver and line up the screw holes with the screw clips on the car panel. Secure the speaker/grille assembly to the car panel with the supplied Allen head screws. Using the base of the surface mount cup as a template, mark the screw hole and drill it using a 1/8 inch drill bit. mark the wire holes (for the tweeter wires) , drill using the 1/4-inch drill bit. Strip 1/8" ­ 1/4" (4-6 mm) of plastic insulation from the cut ends of the tweeter wire. Route the tweeter wire from the crossover through grommets to the tweeter location. Push the red and black tweeter wires through the holes in the bottom of the tweeter cup and though the panel. Slip the male fast-on connector on the red tweeter wire onto the female connector on the white-striped wire from the crossover and the black tweeter wire to the un-striped wire (Figure 2). Make sure the clear plastic insulators fully cover the fast-on connectors otherwise you may short the tweeter leads and possibly damage your amplifier. One important advantage of component systems is their ability, when properly installed, to improve the soundstage created by the music in your car. the soundstage is the musical "picture" made up of the instruments and vocalists. The difference in the soundstage will be dramatic depending on where you mount your tweeters. We recommend a simple experiment that will help you decide the best spot for your tweeters in your car. Complete the installation of your entire system except for the MM tweeters. [. . . ] Some states do not allow the exclusion or limitation of consequential damages, so the above limitation and exclusion may not apply to you. This Warranty gives you specific legal rights which may vary from state to state. This warranty applies only to Products purchased in the United States of America, its possessions, and U. The Warranty terms and conditions applicable to Products purchased in other countries are available from the Polk Audio Authorized Distributors in such countries. [. . . ]