User manual POLK AUDIO LCI-C

[. . . ] Product Disposal--Certain international, national and/or local laws and/or regulations may apply regarding the disposal of this product. For further detailed information, please contact the retailer where you purchased this product or the Polk Audio Importer/Distributor in your country. A listing of Polk Audio Importer/Distributors can be found on the Polk Audio website www. [. . . ] Important Note: LCi Series In-wall Loudspeakers are not magnetically shielded and should not be placed closer than 1' (30cm) from a CRT (picture tube) television or video monitor. If the speaker needs to be installed higher, aim the tweeter up or down as required. ROOM ENVIRONMENT CONTROL Tweeter Switch If your listening room is very reflective, with smooth sheetrock walls, hardwood floors, and non-cushioned furniture, the sound will be overly "bright" and unnatural. selecting the "cut" setting compensates for the effect of reflectivity in a hard room. Tweeter attenuation flattens room response, without hindering higher frequency response, for warmer, more realistic sound and more accurate imaging. PAINTING IN-WALL GRILLES Painting in-wall grilles The LCic is supplied with one perforated aluminum grille, which may be painted. If the speaker is not yet installed, the grille can be removed simply by pushing the clamp screws forward to push the grille off the speaker from the inside. When painting the speaker frame, use the supplied paint masks to carefully mask off the front of the speakers to protect the drivers and baffles. You can do this while the speaker is already installed in the wall (if, for instance, you're repainting the room). If you do not have the paint masks, carefully mask the speaker components using paper and masking tape. If you're using a compressor and spray gun, use the finest, most diffused setting. When the paint is completely dry, press the white cloth scrim into place and carefully reinstall the grille by fitting it into its recess so that it is just resting on the frame. Starting with one corner, go around the speaker and push the grille into the grille notch a little bit at a time. You will feel a positive "snap" when the grille is fully in place. This warranty will terminate automatically prior to its stated expiration if the original retail purchaser sells or transfers the Product to any other party. , warrants, to the original retail purchaser only, that the LCi-IP Speaker on this Polk Audio Loudspeaker Product will be free from defects in material and workmanship for a period of five (5) years from the date of original retail purchase from a Polk Audio Authorized Dealer. , warrants, to the original retail purchaser only, that any AMPLIFIER OR OTHER ELECTRONIC COMPONENT that may be included in this Polk Audio Loudspeaker Product will be free from defects in material and workmanship for a period of three (3) years years from the date of original retail purchase from a Polk Audio Authorized Dealer. To allow Polk Audio to offer the best possible warranty service, please register your new product online at: www. [. . . ] All implied warranties on this Product are limited to the duration of this expressed Warranty. Some states do not allow limitation on how long an implied Warranty lasts, so the above limitations may not apply to you. This Warranty gives you specific legal rights, and you also may have other rights which vary from state to state. [. . . ]