User manual POLK AUDIO LC80FX

[. . . ] Com INSTALLATION RECOMMENDATION FOR OPTIMUM PERFORMANCE Important Note: You should have a thorough understanding of and adhere to all local building and fire codes. Also, you should be familiar with the area behind the wall or ceiling into which you plan to install your speakers. ) When installing your LCi Series In-wall Loudspeakers, be aware of the weight of your particular model (see specification page for the weight of your model) and the sturdiness of the material into which you are installing the speaker. Be aware of any concealed studs, electrical wiring or plumbing in the wall or ceiling into which you are installing the speakers. [. . . ] A "Diffuse" image is defined as one which creates a "cloud" of sound; think of the effect as ambient sounds which fill the environment all around you. A "Solid" image is one which creates a more pinpoint sound; sound is more directional and localized. Ultimately you are the best judge of what kind of surround imaging you prefer. The schematic drawing of the room represents an ideal placement for all speakers in either a 6. SETTING RECOMMENDATIONS LC65FX In-wall Surround Location Surround speakers located close, straight to the sides of your listening area, and approximately six feet off the floor. Surround speakers located behind your listening area and approximately six feet off the floor. LC80FX In-ceiling Surround Location Surround speakers located straight to the sides of your listening area. ROOM ENVIRONMENT CONTROL Wall Distance Switch In-wall and in-ceiling loudspeakers excel when placed more than 2' (60cm) from side walls. If position limitations demand that in-wall loudspeakers be installed closer than 2' (60cm) from side walls, the proximity of the surface can result in a response "bump" between 50 and 200Hz. " The Wall Distance Switch flattens response and tunes out "boominess" without sacrificing deep bass response, for more lifelike sound. PAINTING IN-WALL GRILLES Painting in-wall grilles The LC80FX/LC65FX each come with a perforated aluminum grille. If the speaker is not yet installed, the grille can be removed simply by pushing the clamp screws forward to push the grille off the speaker from the inside. When painting the speaker frame, use the supplied paint masks to carefully mask off the front of the speakers to protect the drivers and baffles. You can do this while the speaker is already installed in the wall (if, for instance, you're repainting the room). If you do not have the paint masks, carefully mask the speaker components using paper and masking tape. If you're using a compressor and spray gun, use the finest, most diffused setting. When the paint is completely dry, press the white cloth scrim into place and carefully reinstall the grille by fitting it into its recess so that it is just resting on the frame. Starting with one corner, go around the speaker and push the grille into the grille notch a little bit at a time. You will feel a positive "snap" when the grille is fully in place. This warranty will terminate automatically prior to its stated expiration if the original retail purchaser sells or transfers the Product to any other party. [. . . ] If this Product is defective in materials or workmanship as warranted above, your sole remedy shall be repair or replacement as provided above. Be liable to you for any incidental or consequential damages arising out of the use or inability to use the Product, even if Polk Audio, Inc. Or a Polk Audio Authorized Dealer has been advised of the possibility of such damages, or for any claim by any other party. Some states do not allow the exclusion or limitation of consequential damages, so the above limitation and exclusion may not apply to you. [. . . ]