User manual POLK AUDIO ATRIUM 55

[. . . ] If you're using a compressor and spray gun, use the finest, most diffuse setting. When the paint is completely dry, carefully fit the grille into its recess so that it is just resting on the cabinet. Starting with one corner, go around the speaker and push the grille into the grille notch a little bit at a time. Be gentle; the grille may be easily bent out of shape by rough handling. [. . . ] Note that one of the terminals on the rear of each speaker is red (+) and the other is black (-). Make certain that you connect the wire from the red terminal of your amplifier or receiver to the red terminal on your speaker and the wire from the black terminal of your amplifier or receiver to the black terminal on your speaker [figure 14]. Most wire has some indicator (such as color-coding, ribbing or writing) on one of the two conductors to help you maintain consistency. 12) Si le support n'est pas retenu fermement sur le mur par les têtes de vis, retirez l'ensemble support /enceinte du mur, resserrez un peu les vis puis réinstallez l'ensemble. 4) Using the keyhole slots in the bracket as a template, mark the installation location of the two keyhole slots with a pencil. You can do this by removing the bracket knobs on the top and bottom of the speaker and removing the bracket, or by leaving the bracket connected to the speaker [figure 9]. Orient the bracket so that the small ends of the keyhole slots are facing "up" according to the direction of installation. Reattach the bracket to the speakers, if you have removed it, by reinserting it into the bracket gap and then tightening the bracket knobs. 5) If you are certain that there is a stud behind the wall surface, drive #10 screws (not included) through the wall and into the stud [figure 10a]. 6) If there is no stud behind the wall at the chosen location, install #10 wall anchors (not supplied) into the wall by following the wall-anchor-manufacturer's instructions. 7) Drive screws into stud or wall anchors, leaving screw heads protruding 1/16" (6mm). Vous pouvez le faire en retirant les boutons du support de l'enceinte et en la dégageant du support, ou en laissant l'enceinte dans son support (figure 9). FIGURES 10a & b Use #10 screw for wall stud, use #10 wall anchors + screw for no wall stud. Use tornillos n° 10 si la pared tiene parales internos, use anclas de pared y tornillos n° 10 si la pared no tiene parales internos. FIGURE 11 Feed speaker wire from wall through bracket wire hole for easy mounting. FIGURE 12 Slide the bracket down on the screw heads to catch the keyhole slots. ALTERNATE SECURE MOUNTING For more solid mounting, screw the bracket directly into a weight-bearing stud on the mounting surface. Attach and remove the speaker from the permanently secured bracket by tightening and loosening the bracket knobs [as shown in figure 13]. SAFETY FIRST When installing Atrium speakers be aware of the weight of your particular model (Atrium45=approx 5lbs/2. 2kg ea) and the weight bearing tolerance of the material to which you are mounting the speaker. If you are not sure of a safe way of mounting your speakers please consult a professional installer, your authorized Polk Audio dealer, or a building contractor. You will maximize the useful life of your Atrium speakers by placing them where they will receive less exposure to the elements. [. . . ] Be liable to you for any incidental or consequential damages arising out of the use or inability to use the Product, even if Polk Audio, Inc. Or a Polk Audio Authorized Dealer has been advised of the possibility of such damages, or for any claim by any other party. Some states do not allow the exclusion or limitation of consequential damages, so the above limitation and exclusion may not apply to you. All implied warranties on this Product are limited to the duration of this expressed Warranty. [. . . ]