User manual POLK AUDIO 5250

[. . . ] I am extremely excited about these Polk Audio/MOMO high performance speakers; this is the first time that the exclusive MOMO Design house of Italy has co-branded a product. We've partnered with them to produce the best sounding, best looking car speakers ever. They may not look like any other Polk Audio speaker, but make no mistake: They contain the latest loudspeaker technology and many of our exclusive sound innovations, like Dynamic Balance® for clean sound and low distortion. You can be assured of outstanding performance and unmatched quality, as well as an exciting new look. [. . . ] Use the speaker grille as a template for marking the locations of the four screw holes. Cut the supplied driver wire (the heavier gauge of the two sets of wire) in half. Attach the wire with the white stripe to the positive (+) terminal screw, and the un-striped wire to the negative (-) terminal screw. Route the driver wire from the crossover location through grommets to the mid/woofer location. Strip 1/8" ­ 1/4" (4-6 mm) of plastic insulation from the cut ends of the driver wire. Unscrew the binding post thumbnuts on the mid/woofers to fully expose the hole in the terminal shaft and slip the other end of the wire into the holes in the input terminals. Tighten the thumb nuts finger-tight (do not over-tighten the nuts as you may strip the threads). Be sure to attach the wire with the white stripe to the positive (red) terminal, and the un-striped wire to the negative (black) terminal. Place the grille over the driver and line up the screw holes with the screw clips on the car panel. Secure the speaker/grille assembly to the car panel with the supplied Allen head screws. Polk/MOMO System Tweeters One important advantage of component systems is their ability, when properly installed, to improve the soundstage created by the music in your car. the soundstage is the musical "picture" made up of the instruments and vocalists. The difference in the soundstage will be dramatic depending on where you mount your tweeters. We recommend a simple experiment that will help you decide the best spot for your tweeters in your car. Complete the installation of your entire system except for the MM tweeters. Connect the wires provided with your tweeters to the tweeter terminals on your Polk/MOMO crossovers. Without running the wires through doors or under upholstered panels, connect your Polk/MOMO tweeters to these wires. Have a friend sit in the passenger's seat while you sit in the driver's seat, each holding a tweeter in hand, or use double stick tape. With music playing, position the tweeters in different locations around the passenger compartment, listening for the differences caused from these placements. You will be able to deter mine in a short time the best location for your tweeters. The soundstage or image should "float" above the dash and not be localized to the physical location of the drivers or tweeters. Both passenger and driver should be able to hear both channels and a stereo image. [. . . ] Authorized Polk Audio dealers are the best source for advice and assistance. Call Polk Audio's Customer Service Department at 1-800-377-7655 from 9am to 6pm, Eastern Time, Monday through Friday. Please do not hesitate to call us if you have questions about your speaker system. Recommended Amplification/ Amplification recommandée Impedance(DCR)/Impédance (DCR) Frequency Response (+/-3dB)/ Réponse en fréquences (+/-3dB) Sensitivity (1w/1m)/ Sensibilité (1w/1m) Cutout Dimensions/ Dimensions de l'embrasure Driver/Transducteur Tweeter Mounting Depth top mount with grille/ Profondeur de montage Montage en surface avec grille Mounting Depth bottom mount/ Profondeur de montage dessous 5" (127mm) 2 3/16" (55. [. . . ]