User manual PLANTRONICS HL 10

[. . . ] COMPONENTS KEY 1 Lifter Power Cord 2 Mounting Strips 3 Microphone 4 Ringer Microphone Jack 5 Handset Height Switch 6 Accessory Jack 7 Stabilizers 8 Nortel i2004 phones only 9 Ringer Microphone 10 Ringer Microphone Plug The HL10 Handset Lifter Accessory is designed to be used with a Plantronics Headset System. The top edge of the lifter should touch the earpiece of the handset when the handset is placed in the cradle (Fig. [. . . ] NOTE: If your phone has an adjustable height, a lower setting may IMPORTANT: Do not remove the mounting strip covers until all Be sure to press firmly for a tight fit. Clean the cradle and speaker areas of the phone and replace the handset. If the handset still does not lift and lower smoothly, your telephone may require the Extender Arm accessory. The Stabilizers (7) can be shifted to the left or right to improve the stability of the handset on the HL10. Read "Adjusting the HL10 for Your Telephone" to determine the correct HL10 height. MOUNTING THE HL10 IN A PERMANENT POSITION Once you have determined the best position for the Handset Height Switch (5), you can mount the HL10 on your telephone base. NOTE: If the side of the phone is curved, the protective cover on the MAKING AND RECEIVING CALLS While wearing your headset, press the talk button to activate the HL10. When you hear a dial tone, use the telephone key pad to dial the number (Fig. the HL10 will return the handset to the cradle and disconnect the call. If your headset does not beep when the phone rings, you may need to adjust the ringer on your phone. If necessary, try different settings of ring pattern and volume until the headset beeps when the phone rings. If your headset still does not ring, attach the Ringer Microphone Plug (10) to your HL10 and place the Ringer Microphone (9) over the ringer speaker of your phone. [. . . ] Contact the Plantronics Technical Assistance Center when service or repair work is required. Unplug the lifter from the amplifier or the amplifier from the power source (wall outlet) before cleaning. [. . . ]