User manual PLANTRONICS DISCOVERY 610

[. . . ] Before getting started, please review the safety booklet included in your package. For additional help, service or support information, refer to your product warranty card or visit www. Om du vill ha ytterligare information om hjälp, service eller support läser du på garantisedeln eller går till vår hemsida på www. Headset Headset status indicator Call control button (on/off) Volume/mute button Optional ear stabiliser Soft gel ear tip a. [. . . ] Look in your Bluetooth device manual for the section that describes how to set up a Bluetooth wireless connection. Move through the menu selections on your phone until the phone display shows "Look for Devices, " or equivalent, as a selection. With your headset turned off, hold down the call control button until the headset status indicator briefly glows blue, then flashes red and blue. The headset is now in discovery mode and will stay that way for 30 seconds. When the phone display shows the scan results, select "6xx Plantronics". When the phone display asks for a passkey, type "0000" and press Enter. En Fitting YoUr HEaDsEt The headset comes with three soft gel ear tips and an optional ear stabilizer. Place the headset into your ear with the elongated side of the ear tip pointing up and forward. If the fit is not comfortable, either too tight or too loose, remove the ear tip from the headset by turning the ear tip to the neutral* position and pulling the ear tip away from the headset. Hold the ear tip with the elongated edge pointing down and push the ear tip post into the opening on the headset. Twist the ear tip to the left for right ear wearing or to the right for left ear wearing. Place the headset into your ear with the elongated side pointing up and forward. USInG ThE oPTIonAL EAR STABILIZER The ear tip stabilizer may be attached to the headset to improve stability. Remove the ear tip from the headset by turning the ear tip to the centre or neutral position* and pulling the ear tip away from the headset. To answer a call, briefly press the call control button or the volume/mute button. aDJUsting tHE VolUME To increase the listening volume of the headset , press the upper end (+) of the volume/mute button. WARNING: Do not use headphones/headsets at high volumes for an extended period of time. Last nUMBEr rEDial To activate last number redial, double click the call control button. NOTE: Last number redial must be supported by your device or mobile phone provider. En Using tHE MUtE To turn the mute on whilst on a call, press both sides of the volume/mute button simultaneously until you hear a beep. MoVing oUt oF rangE As the headset is moved away from the mobile phone or Bluetooth device, the following could occur: · Only the power off function will operate. After 30 seconds, the headset will make one attempt to reconnect to the phone or device. [. . . ] When the phone display shows the scan results, select "6xx Plantronics". When the phone display asks for a passkey, type "0000" and press Enter. The headset comes with three soft gel ear tips and an optional ear stabiliser. Place the headset into your ear with the elongated side of the ear tip pointing up and forward. [. . . ]