User manual PLANTRONICS CS70N WIRELESS HEADSET SYSTEM

[. . . ] Com/productregistration to register your product online so we can provide you with the best possible service. Om du vill ha ytterligare information om hjälp, service eller support läser du på garantisedeln eller går till www. Plug the phone cord that is connected to the CS70 base into the handset jack on the phone. [. . . ] Amber charge indicator light on base will flash while charging and will change to solid amber when fully charged. IMPORTANT: Incorrect positioning can cause noise and interference problems. Rotate Noise-Cancelling microphone until it is pointed towards your chin. To pair another headset to the same base, you must first enable the multi-shift pairing feature. ) the speaking volume minor adjust up button on back of base until the power indicator light flashes. Place a charged headset in charging cradle and red indicator light on base will flash for 2 seconds if the multi-shift pairing feature is enabled. Within 10 seconds of doing so, press either the "+" or "-" listening volume button for 3 seconds until the headset talk indicator lights to indicate pairing mode, and goes out after successful pairing. Repeat steps 1 and 2 if headset and base do not link when call control button is pressed. ) the speaking volume minor adjust down button until the power indicator light flashes. Dial tone should sound through handset (if not, check compatibility--see page 42). The talk indicator lights on both the base and the headset should come on, indicating a successful link. To end a call: Press the call control button on the headset, then hang up the handset. NOTE: If either you or the recipient have trouble hearing, please check compatibility (page 42). Press the call control button on headset to activate handset lifter and lift handset from phone. If you still do not hear a dial tone, you may need to insert extender arm (see page 59) or check compatibility (page 42). To end a call, press the call control button to lower the handset lifter. NOTE: If either you or the recipient have trouble hearing, please check compatibility (page 42). NOTE: The compatibility setting of "1" is set at the factory to work with most phones. [. . . ] However, if you wish to use a replacement headset with the base unit, then the units must be re-subscribed. Extender Arm Use extender arm when the handset lifter needs additional stability lifting and returning to cradle. Ringer Microphone Use ringer microphone when the telephone speaker is not located directly under the handset. [. . . ]