User manual PLANTRONICS 220

[. . . ] CAUTION Do not use headset while charging and do not connect the charger while the headset is in use. This headset comes with QuickPairTM technology so pairing with your Bluetooth phone is even easier. Follow the instructions below to pair your phone with your headset for the first time. [. . . ] WARNING Do not use headphones/headsets at high volumes for an extended period of time. EN USINGYOURHEADSET ADDITIONALFEATURES Redialling Last Number To activate last number redial, double press the call control button. Using Voice Dialling With the headset on, press the call control button for 2 seconds to activate the voice dialling. NOTE To use voice activated dialing, the voice dialling feature must be enabled on your phone. Rejecting a Call When receiving an incoming call, press the call control button for 2 seconds to reject the call. Switching a Call From Phone to Headset To switch an active call from your phone to your headset, press the call control button for 3 seconds. Switching a Call From Headset to Phone To switch an active call from your headset to your phone, press the call control button for 2 seconds. EN INDICATORLIGHTS Headset Status Powering on Powering off Charging battery Low battery Pairing mode Missed call Ringing Headset Indicator Light Blue flashes. EN ACCESSORIES Available for purchase To order, please contact your Plantronics supplier or go to www. SOLUTION Headset was not in pairing mode when mobile phone menu selections were made. Press the call control button for 2 seconds until you hear a beep or see the indicator light glow blue to turn headset on. Press the volume key up (toward the ear loop) to increase the sound heard in the headset. Press the call control button for 2 seconds until you hear a beep or see the indicator light glow blue to turn headset on. Headset can last up to four days without charging, based on average talk time of 1. Up to 6 hours Approximately 200 hours 2 hours Bluetooth standard 33 feet (10 meters) 5V DC ­ 300 mA Lithium Ion Polymer Bluetooth 2. En rEgUlatory noticEs EXPOSURETORFRADIATION The internal wireless radio operates within the guidelines found in radio frequency safety standards and recommendations, which reflect the consensus of the scientific community. Independent studies have shown that the internal wireless radio is safe for use by consumers. FCC REQUIREMENT INFORMATION FCC Requirements Part 15 Operation is subject to the following two conditions: 1. [. . . ] Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. "Privacy of communications may not be ensured when using this telephone. The Plantronics Technical Assistance Center (TAC) is ready to assist you on 866-363-BLUE (2583), or visit the Support section of our Web site at www. [. . . ]