User manual PLANAR XP17WSA Product Manual

[. . . ] PLANAR LCD TV XP17WSA MANUAL www. planar. com TM-17 User's Manual Thank you for using our product. This manual explains the use of our TFT LCD product TM-17 and important points. Built-in TV channel selector for TV viewing. P18 Simultaneous display of PC and TV images. P19 Connectable to PC's analog RGB port and digital port. Built-in auto-adjust function for automatic adjustment of screen display. [. . . ] Turn on the power in the sequence of peripherals (including this product) computer. Use / button to select the desired "basic setting", then press OSD MENU again. In case of Macintosh, boot the operating system and perform steps 2 ~ 4 above after the screen display becomes still. The auto adjust will take a few seconds, during which you won't be able to perform OSD function. If the effect of auto adjust is not satisfactory, carry out manual adjustment. 17 TV Viewing Settings for TV Viewing This product has built-in TV channel selector. You can watch TV by connecting the antenna to the LCD. To watch TV, set the channels by performing the following steps: 1. Make sure antenna or cable TV is connected to TV-IN and then turn on the LCD. Press OSD MENU button (or MENU on the remote) to display OSD Main Menu. Use / buttons (or / on the remote) to highlight the "Display Settings" option, then press OSD MENU (or MENU on the remote) again. Use / buttons (or / on the remote) to select "Auto Program" option, then press + (oron the remote). Use -/+ buttons (or/ on the remote) to adjust volume. Change Channel Use -/+ (oron the remote) to change channels. Use the numeric numbers 0-9 & 100 + to change to specific channels For channels 1-9 1. Push "100+" followed by two numbers 0-9. 18 Displaying TV or VCR Images on PC Screen You can use PIP (Picture In Picture) function to show TV or VCR images on PC screen. Activate the PIP Function Take the following steps to activate the PIP function: 1. Press OSD MENU button (or MENU on the remote) to display OSD Main Menu. Use / button (or / on the remote) to select [Turn picture ON/OFF], then press + button (oron the remote). Use / button (or / on the remote) to select PIP option, then press OSD MENU button (or MENU on the remote). Use / button (or / on the remote) to highlight the option to be changed, then use -/+ buttons (or/ on the remote) to change the setting. Product Care Precaution The panel of this product has a special coating. Use of neutral detergent or detergent bought on the market might cause the peeling of coating. Before cleaning, disconnect the power plug from the AC outlet. Perform cleaning on a stable desktop or flat floor. 19 Troubleshooting Refer to the following section if you experience trouble with the product. If the problem persists, please consult our service center. Computer Screen Problems No image appears on screen 1 Cause It might be poor contact between the LCD cable and LCD or graphic card. 2 Cause It might be poor contact of graphic card installed in the computer. 3 Cause It might be poor contact of memory installed in the computer. Solution 1 3 ~ Turn off the computer power, then reinsert the graphic card, LCD cable and memory. Do not plug or unplug the LCD cable or power cord when the power is ON. [. . . ] The specifications, design and other content of this manual are subject to change for improvement without prior notice. Some descriptions in this manual might differ slightly from the product you have purchased. If there is any question, error or omission, please contact your local dealer or our service center. This product is meant to be used as an office apparatus in office or home setting. [. . . ]