User manual PLANAR PR3020 QUICK START

[. . . ] The information contained in this document is subject to change without notice. This document contains proprietary information that is protected by copyright. [. . . ] Open the OSD Status menu (menu only opens when input device detected) top/bottom) effect the OSD 20. Page up when connected through USB to a PC through USB to a PC through USB to a PC Caution: Overheating can damage the projector. Do not block any of the air vents around the unit. 3 2 IDENTIFY REMOTE CONTROL PARTS Remote Buttons Description 24. Enter key when connected 1. Lights when the remote control is used -- User's Guide -- Remote Buttons Description 26. Turn the projector on or off 5 2 MAKE CONNECTIONS 4 1. INSERT REMOTE CONTROL BATTERIES Remove the battery compartment cover by sliding the cover in the direction of the arrow. Replace the cover. Warning: As a safety precaution, disconnect all power to the projector and connecting devices before making connections. Label Description Receiver for IR signal from remote control Connect the DVID cable from a computer (not supplied) Connect a VGA cable from a computer (supplied) Connect to a monitor (not supplied) Connect S-video cable from a video device (not supplied) Connect a composite video cable from a video device (supplied) Connect the audio cable from an audio input device (supplied) Connect the audio cable from an audio input device (supplied) Connect an audio cable from the computer's audioout connector (supplied) 2. 3. 1. Rear IR receiver DVI-D (For PR5020 only) VGA IN 2. 3. 4. VGA OUT 5. S-video 6. Video 7. Audio in-R 8. Audio in-L 9. Audio-in -- User's Guide -- Label Description Audio loop-thru Connect the USB cable from a computer (supplied) Installation control 10. 7. Press the Menu button and then press the cursor button until Tool is highlighted [D]. (For PR5020 only) 13. Power Connect the power cord (supplied) Secure to permanent object with a Kensington® Lock system 14. Lock Security 7 1. ADJUST PROJECTOR LEVEL To raise the level of the projector, lift the projector [A] and press the height-adjuster button [B]. The height adjuster drops down [C]. 6 1. POWER ON/OFF AND SET LANGUAGE Connect the power cord to the projector [A] . Connect the other end to a wall outlet. Switch [B] from on (O) to off ( ) The POWER and READY LEDs on the projector turn on. [. . . ] Use the remote control cursor buttons to navigate and make changes to the projector settings. Refer to the "On-Screen Display Settings" section of the CD-ROM user manual for more information. -- User's Guide -- [. . . ]