User manual PLANAR GX3MP Product Manual

[. . . ] For lamp-specific disposal information, check WWW. LAMPRECYCLE. ORG. Symbol explanations Disposal. Do not use household or municipal waste collection services for disposal of electrical and electronic equipment. EU countries require the use of separate recycling collection services. Read the accompanying text carefully, for proper operation and maintenance of the display system. [. . . ] Remove the graphics card slowly from its package and static-shielding bag to prevent an electrostatic discharge. When touching the card or parts of the motherboard, take these precautions: · Wear an antistatic wrist strap. · Discharge your body's static electricity repeatedly by touching the power supply or the metal surface of the computer chassis. To install the controller 1 Turn off all peripherals. 4 Insert the graphics card into the slot, align the connector pins, and press the board down until it is firmly seated. When installing multiple graphics cards, install all cards before you install the driver. 7 Making the Connections Use only the DVI cable and power cord supplied with your Planar GX3MP display. To connect the display 1 Plug one end of the DVI cable into the DVI connector port. 3 Plug the other end of the DVI cable into DVI port 1 (the bottom port) on the installed graphics card. 5 Power on your display first, then the computer. Power cord DVI cable 8 Use DVI port 1 (the bottom port) to connect a single display to the graphics card or to install the primary display of a dual configuration. DVI cable DVI port 1 AX3 graphics card installed 9 Installing the Display Driver Before you install the driver, remove any previously installed display driver for the graphics card from your system. To install the driver 1 Start the system. 6 When the Setup complete message appears, select Yes, I want to restart my computer now and click Finish. 7 If the Digital Signature Not Found message appears, click Yes or Continue to complete the driver installation. To set the display mode manually 1 Right-click the desktop and select Properties > Settings. Make sure that the check box for Hide modes that this monitor cannot display is empty (unchecked). Then click Apply or OK. 10 To configure the display 1 Right-click the desktop and select Properties > Settings. Click OK. To use a dual-display configuration 1 Right-click the desktop and select Properties > Settings. Click OK. Display Brightness Install the brightness control application located on the driver CD. Do not adjust display brightness via the control panel. To install the brightness control 1 2 3 4 Load the driver CD, open the Brightness Control folder, and run Setup. exe. Check the install destination; set a different destination, if desired. Click Finish upon completion. To run the brightness control 1 Select Start > All Programs > Planar GX3MP > Brightness Control Slider. Click and drag the slider left or right (or use the arrow buttons) to set brightness. 3 Click OK. 11 Display Positions Use both hands when you make adjustments to the display position. Tilt range Height range Adjust the tilt angle of the display so that the screen faces slightly downward from your angle of view. Orientation mode Unfasten the stand lock at the top of the desk stand (slide it to the left) then adjust the height. [. . . ] FCC Compliance Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ]