User manual PLANAR CT1905S Product Manual

[. . . ] "Le présent appareil numérique n'èmet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la class B prescrites dans le Règlement sur le brouillage radioélectrique édicté par le ministère des Communications du Canada" i Preface Important Safety Instructions Please read the following instructions carefully. To clean the LCD Monitor screen, first, make sure the Monitor is in the power off mode. Stand away from the LCD Monitor and spray cleaning solution onto a rag. Without applying excessive pressure, clean the screen with the slightly dampened rag. [. . . ] (You can also connect your CD-ROM's Line out to this jack. ) Stereo Headphone Jack Stereo headphones may be connected to the headphone jack. 6. Adjusting the Viewing Angle Your LCD Monitor can be adjusted both horizontally and vertically. Connecting AC Power Plug the female end of the power cable into the AC power connector. The plug on the power cable will vary according to the electrical standard in your area. 3 Chapter 1 Connecting Video 1. Before connecting your monitor to the PC, please power-off both devices. Connect one end of the VGA signal cable to the PC's 15-pin VGA port and the other end to the monitor 15pin VGA port. 3. 4. Connect one end of the DVI signal cable to the PC's 24-pin DVI port and the other end to the monitor 24-pin DVI port. Make sure the signal cables are securely connected to both the monitor and PC. Tighten the connecting screws to ensure a secure connection. If both analog (15-pin D-sub VGA) and digital (24-pin DVI) input ports are connected at the same time, the signal input can be selected with the port select button. Please go to the next chapter for details. Connecting the Stereo Speakers 1. Connect the 1. 5M audio cable to the Line-OUT of your PC's audio card. Connect the opposite end of the 1. 5M audio cable to the LCD Monitor's line-IN connector. 4 Planar User's Manual Connecting the Optional Touch Screen Your LCD Monitor has an optional touch screen feature. Use the FUNCTION select buttons to scroll between the submenu items Contrast: Use the Adjust keys to adjust the difference between the lightest and darkest areas on the display. Brightness: Use the Adjust keys to adjust the intensity of the monitor backlight. Speaker Volume: Use the Adjust Graph/Text: Use the Adjust to change between DOS graphic 640x400 or 720x400. Auto Adjust: While the Auto-Adjust sub-menu is selected, press the Adjust key to activate the Auto Adjust procedure. Once finished, the OSD menu will disappear after a short time-out period. Exit: Press the Adjust key to exit the Graphic-Control submenu. Geometric Menu Pressing the Adjust key on the monitor activates the Geometric submenu. You should only use this menu item if the results of the Auto Adjust function are not satisfactory. Scale: Press the Adjust key to change to full screen scaling or native resolution. An improper clock setting will result in wide vertical bands on the display. An improper phase adjustment will result in pixel jitter or display noise. Horizontal Position: Press the Vertical Position: Press the Exit: Press the Adjust Adjust Adjust keys horizontally move the display image to the desired position. [. . . ] If there is still no display, press the other Adjustment Control button several times. If step 2 doesn't work, connect your PC system to another external CRT Monitor. If your PC System function properly with a CRT Monitor but it does not function with the LCD Monitor and the LCD Monitor's power LED is blinking, the output timing of the PC's VGA card may be out of the LCD's synchronous range. Please change to an alternate mode listed in Addendum or replace the VGA card and repeat steps 1 and 2. [. . . ]