User manual PINNACLE MCE REMOTE QUICK GUIDE

[. . . ] The IR sensor lens is typically visible on the front of the set-top box. If you can't find the IR sensor lens, see the documentation that came with your set-top box. Using the Remote Control You use the remote control to interact with most of the features in Media Center. Just point the remote control at the receiver, and then enter your commands. Your remote control has five types of buttons: · Navigation buttons, to move between items on the screen. [. . . ] To program buttons on the remote control by using the learning feature 1 Place the remote control for Media Center PC head to head (2 to 3 inches apart) with the remote control from which it is learning. 2 On the remote control for Media Center PC, press and hold the DVD MENU and OK buttons at the same time until the remote control lights turn off (2 seconds). 3 On the remote control for Media Center PC, press and release the TV, VOL +, or VOL ­ button, depending on which command you want it to learn. The remote control for Media Center PC lights blink once to confirm the selection. 4 On the remote control that is teaching the command, press and hold the button that you want the corresponding button on the remote control for Media Center PC to learn. The remote control for Media Center PC lights blink twice to confirm the selection. If the remote did not learn the command, the lights blink quickly four times. 5 Repeat steps 1 through 4 for the other buttons that can learn commands. To restore the default remote control settings 1 Press and hold the DVD MENU button and LEFT navigation button at the same time until the remote control for Media Center PC lights turn off. The remote control for Media Center PC lights blink twice to confirm that the buttons have been reset. The TV button will have no command assigned to it and the VOL + and VOL ­ buttons will adjust the Media Center PC system volume. If the default settings were not restored, the lights blink quickly four times. To try again, repeat steps 1 and 2. 7 Troubleshooting If you don't find the solution you're looking for in this section, see Media Center Help for additional troubleshooting information. The battery power could be low or the batteries could be inserted incorrectly. When I press a button on the remote, backlighting appears but nothing happens. Make sure that the following is true: · You are pointing the remote control directly at the receiver. · The IR sensor on the receiver is not covered up, and no natural or artificial light is shining directly on it. To reactivate Media Center, move the mouse, and then click anywhere in the Media Center window. My remote control for Media Center PC doesn't turn my TV on or off. Make sure that the following is true: · You pressed the TV button, rather than another button. · The POWER button on the TV remote control is working properly. If it's not, the remote control for Media Center PC might not receive the correct IR code. [. . . ] If you acquired this Hardware outside of the countries listed above, then local laws may apply. Information in this document, including URL and other Internet Web site references, is subject to change without notice. Unless otherwise noted, the example companies, organizations, products, domain names, e-mail addresses, logos, people, places, and events depicted herein are fictitious, and no association with any real company, organization, product, domain name, e-mail address, logo, person, place, or event is intended or should be inferred. Complying with all applicable copyright laws is the responsibility of the user. Without limiting the rights under copyright, no part of this document may be reproduced, stored in or introduced into a retrieval system, or transmitted in any form or by any means (electronic, mechanical, photocopying, recording, or otherwise), or for any purpose, without the express written permission of Microsoft Corporation. [. . . ]