User manual PHILIPS HF3471

[. . . ] Warning Check if the voltage indicated on the appliance corresponds to the local mains voltage before you connect the appliance. the appliance is suitable for mains voltages of 230V and frequencies of 50Hz. If the mains cord is damaged, you must have it replaced by Philips, a service centre authorised by Philips or similarly qualified persons in order to avoid a hazard. The lamp and the metal part of the top cover become hot during use and you may burn your fingers when you touch them (Fig. [. . . ] 2 Press the light intensity + and - buttons to select a light intensity (Fig. Note:The light intensity you have selected is automatically set as the light intensity level for the alarm as well. Tip:When you use the appliance for the first time, set the light intensity to 20. The moment you wake up, check which light intensity level the appliance has reached by briefly pressing the light intensity + or button. When you do this, the current alarm light intensity level appears on the display. Setting the alarm When you set the alarm, you choose an alarm time and the type of sound you want to wake up to. The light intensity slowly increases to the selected level during the last 30 minutes before the set alarm time. The sound slowly increases in 90 seconds to the selected level after the set alarm time. Note:You can set the light intensity by pressing the light on/off button and then pressing the light intensity + or - button and you can set the alarm volume by pressing the volume increase or decrease button. If you do not want to wake up to the lamp or to a sound, set the light intensity or volume level to OFF. see sections `Using the lamp' and `Radio/volume' in this chapter. 1 Push the control lever down to the middle position to switch on the alarm (Fig. If this is not the case, push the control lever up and down again to enter the alarm time mode. Switching off the alarm To switch off the alarm function, push up the control lever to the top position. 19) snoozing 1 Push down the control lever to the bottom position when the alarm goes off (Fig. , The lamp continues to be on at the selected intensity level, but the alarm sound stops. Note: If you push down the control lever with too much force, it may jump back to off position. Alarm demonstration If you want to get a quick demonstration (60 seconds) of the gradually increasing light level and sound level, activate the test function of the appliance. 1 Push the control lever down to the bottom position for a few seconds until TEST appears on the display (Fig. Note:The appliance continues to run the alarm demonstration until you push down the control lever again. Tip:To make sure you get a good radio signal, fully unwind the antenna and move it around until you have found a position at which reception is best. Note:The volume level you have selected is automatically set as the volume level for the alarm as well. [. . . ] The alarm did not go off 9 minutes after I pushed the control lever down to snooze. The light wakes me too late Perhaps you pushed the control lever down with so much force that it jumped to off position. Perhaps the light intensity level you have set is not appropriate for you. If light intensity 1 is not low enough, move the appliance further away from the bed. [. . . ]