User manual PHILIPS FC8133/01

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual PHILIPS FC8133/01. We hope that this PHILIPS FC8133/01 user guide will be useful to you.


PHILIPS FC8133/01 : Download the complete user guide (26789 Ko)

Manual abstract: user guide PHILIPS FC8133/01

Detailed instructions for use are in the User's Guide.

[. . . ] -- When you use the vacuum cleaner to vacuum ashes, fine sand, lime, cement dust and similar substances, the pores of the dustbag and the motor protection filter become clogged. If you notice a strong decrease in suction power, replace the dustbag and clean the motor protection filter. -- Always unplug the appliance before you replace the dustbag or clean the filters and assemble or disassemble accessories. -- Never use the appliance without a dustbag or the motor protection filter. [. . . ] 2 To detach the mini turbo brush, pull it out of the handgrip or the telescopic tube while turning it a little. Using the appliance Vacuum cleaning 1 Pull the cord out of the appliance and insert the mains plug into the wall socket. 2 Press the on/off button on top of the appliance with your foot to switch on the appliance. English Note:You can carry the vacuum cleaner by the handle at the front of the appliance. 11 Adjusting suction power You can adjust the suction power with: -- the suction power slide on the handgrip. Cleaning and maintenance  The plug must be removed from the socket-outlet before cleaning or maintaining the appliance. 1 Switch off and unplug the appliance before you remove and clean any parts. 12 English Cleaning the HEPA exhaust filter To maintain optimal performance, clean the HEPA filter each time you replace the dustbag. 1 To open the HEPA exhaust filter grille, grab the tabs and pull the grille upwards to remove it from the appliance. -- Hold the filter in such a way that the pleated side points upwards and the water flows parallel to the pleats. Hold the filter at an angle so that the water washes away the dirt inside the pleats. -- Turn the filter 180° and let the water flow along the pleats in the opposite direction. Note: Cleaning does not restore the original colour of the filter, but does restore its filtration power. 4 Carefully shake the water from the surface of the HEPA exhaust filter. Let the HEPA exhaust filter dry completely before you put it back into the vacuum cleaner. 6 To close the HEPA exhaust filter grille, first align the lugs on the top of the grille with the slots in the appliance (1). Then press the tabs downwards until the grille locks into place (2) (‘click’). English Cleaning the motor protection filter 13 To maintain optimal performance, clean the motor protection filter at least once a year. Make sure you hold the dustbag upright when you lift it out of the appliance. 3 Pull the filter holder with the motor protection filter out of the appliance. 5 Put the filter in the filter holder and slide the filter holder back into the appliance. Cleaning the mini turbo brush (specific types only) To clean the brush inside the mini turbo brush, follow the steps below. [. . . ] -- Perhaps the electronic suction power control is set to a low setting. To remove the obstruction, disconnect the blocked-up item and connect it (as far as possible) the other way round. Switch on the vacuum cleaner to force the air through the blocked-up item in opposite direction. 2 Specific types only: hairs are entangled around the brush inside the mini turbo brush. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE PHILIPS FC8133/01




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual PHILIPS FC8133/01 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.