User manual PHILIPS 7007631PU

[. . . ] Do not use appliance if foil, cutters or trimmers are damaged as injury may occur. Never put the appliance in direct sunlight or store at a temperature above 140°F (60ºC). To prevent possible damage to the cord, do not wrap cord around the appliance. Only use the power plug and other accessories supplied with the appliance. [. . . ] Before First Use Important -- Before putting on or taking off any parts or performing any cleaning, maintenance or storage, be sure to turn appliance off, unplug from outlet and remove power cord from appliance. Charging/(re)charging -- Charging or (re)charging at temperatures below 40°F or higher than 95°F adversely affects lifetime of batteries. 1 Connect the small plug directly to the appliance and connect the charging plug into any 100V to 240V AC outlet. -- An adapter plug may be necessary for charging plug usage in some foreign countries. Use an attachment plug adapter of the proper configuration for the power outlet. The charging plug will automatically convert to work on 100V to 240V AC systems. Indd 10 11/12/12 11:36 AM English 11 2 Charging and (re)charging requires 1 full hour for a cordless shaving time of up to 40 minutes. Note: First time charging or charging after a long period of non-use requires 90 minutes of charge time. - When the battery is fully charged, the battery symbol lights up green continuously. Tip: Depending on your shaving/styling behavior and beard type, the operating time may vary over time. Quick Charge The quick charge is indicated by the green battery symbol and orange plug symbol blinking alternately. Cleaning -- Do not use abrasive cleaning agents, scourers or aggressive liquids such as gasoline to clean the appliance and attachments. -- While rinsing the appliance, water may drip out of the base of the appliance. Cleaning the Shaving Unit 1 Rinse the shaving unit under hot water for a couple of minutes. Indd 16 11/12/12 11:36 AM English 17 2 Press the shaving unit release buttons (1) and pull shaving unit off the shaving attachment (2). 4 Carefully shake off excess water and let the shaving unit air dry thoroughly. Never dry the shaving unit with a towel or tissue as damage may occur to the shaving heads. Note:You can also clean the shaving attachment and shaving unit with the supplied brush. Extra-thorough Cleaning Method 1 Press the shaving unit release buttons (1) and pull shaving unit off the shaving attachment (2). 2 Unlock the orange retaining ring by turning it in the direction of the arrows on the retaining ring. Indd 17 11/12/12 11:36 AM 18 English 3 Lift the retaining ring out of the shaving head holder. Tip: Do not clean more than one cutter and comb at a time as they are matching sets. [. . . ] Indd 19 11/12/12 11:36 AM 20 English 2 Remove the shaving heads and place new ones in the shaving head holder making sure the two wings of the shaving heads fit exactly into the recesses. 3 Reattach the retaining ring (1) by turning it the opposite direction of the arrows on the retaining ring (2). Make sure the four wings of the retaining ring are located exactly under the recesses of the shaving head holder. If it does not close smoothly, check that the shaving heads and retaining rings are positioned properly. [. . . ]