User manual PHILIPS 40767-17-16

[. . . ] 4) a B C D E F g H Protection cap Shaving unit Shaving unit release button Shaver on/off button with power-on symbol Display (all types except HQ8200) Trimmer Cleaning brush Storage pouch (your pouch may differ from the one shown in the figure) i Adapter J Small plug k Bathroom stand (HQ8251/HQ8250 only) the display (all types except HQ8200) The HQ8251, HQ8250, HQ8241 and HQ8240 have different displays, which are shown in the figures below. Note:When you disconnect the shaver from the mains, the CHARGE light stops flashing. 'Battery low' indication (HQ8251/HQ8250 only) Note: If the rechargeable battery runs low during shaving, you can connect the shaver to the mains to finish the shave. - When the battery is almost empty (when there are only 5 or fewer shaving minutes left), the LOW light goes on. [. . . ] HQ8241/HQ8240: Charge the shaver when the motor stops or starts running slower. When you charge the shaver for the first time or after a long period of disuse, let it charge for 12 hours. Tip:To optimise the battery capacity, fully charge the shaver and then use it normally until the battery is completely empty. If you optimise the battery capacity in this way, you can also charge the shaver in between shaves, even if the battery is not completely empty yet. If you have a heavy beard, the shaver may provide less than 17 cordless shaves. The shaving time may also vary over time, depending on your shaving behaviour, cleaning habits and beard type. Using the shaver Note:The HQ8200 can only be used directly from the mains. Note for all types except HQ8200:You can also use the appliance without charging. Shaving 1 HQ8200: Put the small plug in the shaver and put the adapter in the wall socket. - Your skin may need 2 or 3 weeks to get accustomed to the Philips shaving system. 5 HQ8200: Remove the adapter from the wall socket and pull the small plug out of the shaver. Replacement For maximum shaving performance, we advise you to replace the shaving heads every two years. Only replace the shaving heads with original HQ9 Philips Shaving Heads. Make sure that the projections of the shaving heads fit exactly into the recesses. 5 Put the retaining frame back into the shaving unit and turn the lock clockwise. Note: If the shaving unit does not close smoothly, check if you have positioned the shaving heads properly and if the retaining frame is locked. Accessories The following accessories are available: - HQ9 Philips Shaving heads - HQ110 Philips Shaving Head Cleaning Spray (not available in some countries) - HQ8010 car cord. Environment - Do not throw away the appliance with the normal household waste at the end of its life, but hand it in at an official collection point for recycling. - All types except HQ8200: The built-in rechargeable shaver battery contains substances that may pollute the environment. Always remove the battery before you discard or hand in the shaver at an official collection point. dispose of the battery at an official collection point for batteries. If you have trouble removing the battery, you can also take the appliance to a Philips service centre. [. . . ] The staff of this centre will remove the battery for you and will dispose of it in an environmentally safe way. Removing the rechargeable shaver battery (all types except HQ8200) Only remove the rechargeable battery when you discard the shaver. Make sure the rechargeable battery is completely empty when you remove it. 2 Let the shaver run until it stops and undo the two screws in the back of the shaver. [. . . ]