User manual PHILIPS AVENT DECT SCD510

[. . . ] νικα 37 Español 49 Suomi 60 Français 70 Italiano 80 Nederlands 91 Norsk 101 Português 111 Svenska 122 Türkçe 132 SCD510 6 English Introduction Congratulations on your purchase and welcome to Philips AVENT!To fully benefit from the support that Philips offers, register your product at www. Philips AVENT is dedicated to producing caring, reliable products that give parents the reassurance they need. This Philips AVENT baby monitor provides round-the-clock support by ensuring you can always hear your baby clearly without any distracting noise. [. . . ] If your baby cries, you see the sound level lights light up on the parent unit. -- As long as the baby unit does not detect a sound, all sound level lights on the parent unit are out. -- When the baby unit picks up a sound, one or more sound level lights on the parent unit go on. The number of lights that go on is related to the loudness of the sound picked up by the baby unit. Nightlight 1 Press the nightlight button Q on the baby unit to switch on the nightlight. €23) 2 Press the nightlight button Q again to switch off the nightlight. Tip: Switch off the nightlight when you operate the baby unit on the non-rechargeable batteries. English 11 Paging the parent unit If you have misplaced the parent unit and its volume is switched off, you can use the PAGE button on the baby unit to locate the parent unit. Note:The paging function only works when the parent unit is switched on. Out of range alert When the parent unit is out of range of the baby unit, the parent unit beeps from time to time. Note:The LINK light on the parent unit also flashes red when the baby unit is switched off. Microphone sensitivity You can set the microphone sensitivity of the baby unit to the desired level with the SENSITIVITY button on the parent unit. You can only change the microphone sensitivity when a connection between the baby unit and the parent unit has been established, i. Cleaning and maintenance Do not immerse the parent unit and the baby unit in water and do not clean them under the tap. 1 Unplug the baby unit or the parent unit if they are connected to the mains. Storage -- When you are not going to use the baby monitor for some time, remove the non-rechargeable batteries from the baby unit and the rechargeable batteries from the parent unit. Store the parent unit, the baby unit and the adapters in a cool and dry place. Replacement Baby unit Batteries Only replace the non-rechargeable batteries of the baby unit with four 1. Note:We strongly advise you to use Philips non-rechargeable batteries. Adapter Only replace the adapter of the baby unit with an adapter of the original type. You can order a new adapter from your dealer or a Philips service centre. -- UK only: S004LB0750040 (UK) -- Other countries: S004LV0750040 (EU) Parent unit Batteries Only replace the rechargeable batteries of the parent unit with two NiMH AAA 850mAh batteries. [. . . ] -- Hverken baby- eller forældreenheden må udsættes for ekstrem kulde eller varme eller for direkte sollys. -- Placer altid genopladelige batterier af den korrekte type i forældreenheden for at undgå eksplosionsfare. undgå at bruge ikke-genopladelige batterier for at undgå eksplosionsfare. -- Brug altid ikke-genopladelige batterier af den korrekte type i babyenheden for at undgå eksplosionsfare. [. . . ]