User manual PFAFF TIPMATIC 1025

[. . . ] Then draw it back into slot B, into thread guide 50 and into the right thread guide Don the needle holder. For two-needle sewing, draw one thread into slot Ato the left of guide C, and draw the other to the right of guide C. One of the threads is then pulled into the right thread guide, the other into the left. V Disengaging the sewing mechanism Before you start winding the bobbin, disen gage the sewing mechanism. [. . . ] 5 Winding the bobbin from a second spool (A) Disengage the sewing mechanism. Pull the thread from the spool, lead it around bobbin tension stud 55, wind it around the bobbin a few times and push the bobbin toward the right to start the winder. Winding the bobbin through the needle eye (B) Raise the sewing foot and bring the needle to its highest point. Draw the needle thread under the sewing foot, up and into slot 54, and from above around bobbin tension stud 55. Pull out latch K, then lift out the bobbin case, release the latch and take out the bobbin. Inserting the bobbin Insert the filled bobbin into the bobbin case so that the thread unreels toward the back (A>. 7 Inserting the bobbin case Pull out latch K and push the bobbin case onto stud B, making sure slot A is up. Release the latch and lightly press against the bobbin case to make sure it has snapped into place. Turn hand wheel 32 toward you until the needle movesdownand upagainandthetake-up lever is up. Pull the bobbin thread out of the needle hole and lay both threads toward the left and back under the sewing foot. 8 Presser bar lifter Lever 42 has three positions: A = The sewing foot is raised. Then hold the needle, loosen screw A and pull the needle out downwards. Insert a new System 1 30/705 H needle (with the flat side of its shank facing toward the back) and push it up as far as it will go. 16 Changing the sewing foot To release the sewing foot push the red button A. Place the sewing foot under the sewing foot holder and hold it in place with your left hand. Lower presser bar lifter 42 and at the same time reposition the sewing foot so that stud B fits in slot C. 17 Special sewing feet A Blindstitch foot Blindstich guide E is adjusted by turning screw D. B Zipper foot First insert its rear pin into groove F, then push its front pin into groove G. The zipper foot can be adjusted sideways for stitching along the right or left zipper chain. C Darning foot Remove the sewing foot holder and secure the darning foot in position with screw H. Regulate the stitch density in the buttonhole range of the stitch length control (B). Insert the filler cord as follows (C): Place it over the rear lug of the foot, pull it taut and clamp it in front lug D. [. . . ] Sewing buttonholes Pull the bottom of the buttonhole foot for ward as far as it will go. 2 Push button 20 and keep it depressed until the machine has sewn 4 to 6 bartacking stitches. 3 Push button 21 Sew the second button hole seam the same length as the first. 4 Push button 20 and keep it depressed until the machine has sewn 4 to 6 bartacking stitches. [. . . ]