User manual PEUGEOT ELYSEO 125

[. . . ] Owners manual Information Information /Prolonged immobilisation . . . . . . . . . . . . . . . . . . . . . . . . 2-3 Equipment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Instrument panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The charge must be carried out with a suitable battery charger with a maximum output of 0. 4 to 1 ampere ; we recommend that this operation is done by a dealer. Note : you can damage the battery if the battery charger that you use is too powerful. - When charging or using in a closed location, make sure that the ventilation is good. - When checking the battery electrolyte level or adding distilled water, make sure that the air vent pipe is properly connected to the battery. Use demineralized water or special lead battery water only for your battery; tap water will reduce its life. It is essential that used batteries must be taken to an approved recycling point. Do not allow the electrolyte to come into contact with your skin, eyes or clothes. Immediately call a doctor Internal : do not drink or provoke vomiting. Connections to battery wires - Connect the red wire to the battery's (+)terminal - Connect the green wire to the battery's (-) terminal 2 1 2 - Fuse Two fuses protect the electrical installation against short-circuits or overloads. - 5A accessory fuse - 20A general fuse They are placed in a fuse box next to the battery. It melts and cuts off the circuit in the event of a failure in the installation. Precaution If one of the fuses is melted, this means there is a failure on the electric circuit. Replace a burnt out fuse with a fuse of the same intensity. * According to the model 10 Lighting and signalling A Lighting and signalling equipment in good working condition is essential for safety. Check the various lamps from time to time before starting and when using your scooter to make sure that they are working as they should. - Lamp characteristics Headlight/Diplight . . . . . . . . . . . . . . . . . . W1, 2W T5 (no base) Number plate light . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . W5W(T10) All lamps are 12 volts See your dealer or distributor immediately if one of the lamps is not working properly. B - Changing the bulbs FRONT : Headlight : - Remove the 4 screws A from the front panel - Tip the fairing forward - Remove the 4 headlight fixation screws B - Change the bulb To adjust the headlight : unclip the container in the bottom of the LH side glove compartment and turn the adjustment screw C in order to set the vertical orientation. Indicators : - Remove the screw E and the lens - Change the bulb C D E E REAR : Rear light : - Remove the 2 screws D and the lens - Change the bulb Indicators : - Remove the screw E and the lens - Change the bulb NUMBER PLATE : - Remove the screw F - Remove the 2 support screws from the bulb holder cover - Change the bulb F 11 Starting the engine - With the electric starter For safety reasons : - Put the scooter on its central stand The electric starter will not work unless you squeeze the left brake lever. To start the engine : - Turn the ignition key A to the position - Squeeze the brake lever - Press the starter button B - Release the button when the engine starts When the engine is cold, keep the throttle closed. Exhaust gases contain carbon monoxide and toxic gases. A Stopping the engine and parking After stopping the scooter : - Only turn off the ignition when the engine is at idling speed - Put the ignition key A to - Put the vehicle on its stand - Remove the key to prevent risks of theft - Parking on the stand - Avoid driving or parking on easily inflammable materials (eg : dry leaves, . . . ) The stand is fitted with a lever to park the scooter easily. - Move to the left side of the scooter - Hold the scooter by its handlebar and the grab handle at the back of the saddle - Push the stand lever with your right foot while pulling the scooter backwards with the handlebars and the saddle's grab handle B - Placing on side stand * Bearing in mind that the isde stand is equipped with an automatic lift mechanism, be careful when carrying out different operations on the vehicle. Caution Make sure that the vehicle is stable on its stand so that it cannot fall over and possibly cause any body wound or any damage to the scooter. * According to the model 12 Running in and driving - Running Running in has an essential influence on correct operation, power and long life of your engine. During the first 500 kilometers, never run your scooter at maximum speed, particularly when cold or going down hill. [. . . ] However, if the rider can prove that he is the owner of the vehicle, our Peugeot dealer can order all the items of this system. A LED warning light blinks on the instrument panel 4 to show that the system is actuated (dissuasive effect). To save the battery, this LED stops blinking after 48 hours, although the system is still operational. Important We advise you not to use the Master Key (red key) for everyday use but to keep it in a safe place with the number of the keys. * According to the model 18 Specifications 125 cm3 150 cm3 Dimensions (mm) Overall length . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]